ELEMENT AS-JACKET WATER HEATER 2170443 - Caterpillar

If collecting a bottle sample, use the same S O S valve (11) and a 169-8373 Bottle Group (13). Refer to Illustration 12.
Record an oil sample reading from the S O S valve (11) on the filter cart at the beginning of the filter cycle.
Activating the machine's steering and work tools can be hazardous when personnel are working around the machine.Before moving the machine, make sure the machine is on firm level ground. Engage the parking brake. Make sure the area is clear of personnel before activating any work tool.Failure to follow this instruction could result in injury or death.
During the filter cart operation, run the engine for 5 minutes every half hour. Running the engine will cycle the clean tank oil into the transmission system and flush the more contaminated oil back into the tank. Turn off the engine. The oil can be filtered while the engine is running.
Stop the procedure after 30 minutes of filtration. Change the transmission filter. Changing the filter allows the filters to assist in the cleaning of the transmission system. The new filter can remain in place until the next scheduled filter change. Changing the filter at this time avoids opening the filter housing after the system has been cleaned. An open filter housing is an inlet for contamination.
Illustration 13 g01282718
Filter cart operation on a 777D OHT
(14) 188-3242 Filter Cart
Operate the filter cart (14) until the portable particle analyzer indicates that the oil has reached an ISO level of at least 16/13. The final ISO level should be recorded before the machine is returned to the field.Note: Refer to"Oil Compartment Times for 188-3242 Filter Cart" locatedat the end of this document when a 170-8500 Analyzer Gp is not available.
When the target ISO level or the time interval has been met, close the air supply valve (10). Disconnect the air supply hose (9). Refer to Illustration 9.
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin. At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the cooling system pressure cap is cool enough to touch with your bare hand.Remove the cooling system pressure cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Illustration 14 g01282719
(15) Probe
(16) S O S valve (located on the fill cap adapter)
To relieve possible tank pressure, use a probe (15) from the 169-8373 Bottle Group and depress the S O S valve (16) that is located on the fill cap adapter. Refer to Illustration 14.
Disconnect the filter cart return line (7) from the fill cap adapter side return port (8). Refer to Illustration 8.
Disconnect the filter cart suction line (5) from the fill cap adapter center suction port (6). Refer to Illustration 7.
Remove the 193-5903 Fill Cap Adapter (2). Refer to Illustration 5.
Install protective caps to the fill cap adapter, the filter cart suction