ELEMENT AS 4420109 - Caterpillar

3. Remove plugs from test ports (11) and (12).4. Remove synchronizing pin (13) from the fuel setting cover. Remove the washer from the synchronizing pin. Install the synchronizing pin in test port (14). Tighten synchronizing pin (13) to a torque of 10 2 N m (90 18 lb in). 5. Remove bolts (21) that hold the top cover in position on the governor. Make sure that the oil level of the governor is below the joint face of the top cover and the governor housing. This will eliminate the loss of oil due to spillage.Remove top cover (22) and gasket (23). 6. Install the 4C6101/4C6099 Terminal Shaft Torque Arm (14) on the terminal shaft and turn the shaft to a fully clockwise (CW) position.The Terminal Shaft Torque Arm handle must point toward the center of the engine and be within 30° horizontal when it is installed and turned clockwise (CW). Hold the shaft in position and hang the 4C6103 Weight [4.0 kg (9.0 lb)] (15) on the hole in the handle of the arm.The arm and weight are used to hold the terminal shaft of the governor in the full clockwise (CW) position. This puts the fuel control linkage stop lever against the end of the synchronizing pin. 7. Install the 4C6098 Speeder Shaft Torque Arm (24) on the speeder shaft and turn the shaft clockwise (CW) to a full throttle position.The torque arm handle must point toward the radiator and be within 30° of horizontal when it is installed and turned clockwise (CW). Hold the shaft in position and hang 4C6102 Weight (25), [2.3 kg (5.0 lb)] on the hole in the handle of arm. The arm and weight are used to hold the throttle (speeder shaft) in the "FULL ON" position. The use of the Torque Arms and Weights, puts the fuel control linkage in position for adjustment. DO NOT OPERATE THE ENGINE WITH THESE TOOLS ON THE GOVERNOR. THE TOOLS ARE DESIGNED FOR ADJUSTMENT PURPOSES ONLY.8. Install and zero the indicator. Either an 8T1000 Electronic Position Indicator Group, or, the 6V3075 Dial Indicator are acceptable to use. Installation instructions for both indicators are as follows:* 8T100 Electronic Position Indicator Group - Install the 5P4814 Collet in test port (12). Slide the 8T1002 Probe with the 5P7263 Contact Point into the 5P4814 Collet until 8T1002 Probe sleeve bottoms in the 5P4814 Collet. Tighten the collet enough to hold the probe in this position. Attach the probe to the 8T1001 Indicator. Turn the indicator ON and set it to measure millimeters. With the indicator ON, touch the zero button. The indicator is now ready to be used for the adjustment.* 6V3075 Dial Indicator - Install the 5P4814 Collet in test port (12). Slide the 6V3075 Dial Indicator with the 5P7263 Contact Point into the 5P4814 Collet. When the contact point seats against the fuel stop lever, slide the indicator IN or OUT, until the indicator dial reads "ZERO". Tighten the collet enough to