ELEMENT AS 4710777 - Caterpillar

4710777 ELEMENT AS Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4710777
471-0777
4710777

Weight: 4 pounds 2 kg.

Buy ELEMENT AS 4710777 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

MAKO AIRTEK Air Filter Compatible with Caterpillar (471-0777)

$258.00

09 Jan 2025

CN: MAKO PARTS

MAKO AIRTEK Air Filter Compatible with Caterpillar (471-0777)
MAKO AIRTEK MAKO AIRTEK Service: 24/7 for your after-sale problems. || Easy installation: Perfect match for the original machine. || RELIABLE MAINTENANCE: The item can directly replace damaged or faulty original item to achieve reliable maintenance || LONG SERVICE LIFE:Excellent performance and long service life || CORROSION RESISTANT MATERIAL: Made of good quality materials, with good corrosion resistance and non interference performance

Air Filter Element Fits Caterpillar 471-0777 4710777

$243.00

21 May 2024

CN: Waiding

Air Filter Element Fits Caterpillar 471-0777 4710777
CERYNiTIS Part Number：4710777 || Application: for Caterpillar 471-0777 4710777

This part in 3 request: Show. This information for suppliers only!

#985066 471-0777

2022-10-07

#982876 471-0777

2022-10-04

#979501 471-0777

2022-09-28

Number on catalog scheme: 3

Caterpillar 4710777 Parts scheme ELEMENT AS

For full view, you need register

Information:

The throttle switch uses resistors to modify the voltage signal from the ECM. The resistance of the switch changes dependent on which position the switch is in. The ECM uses the signal voltage to determine which mode has been selected.
Illustration 1 g03117957
View of the signal voltage range for the throttle switch
Illustration 2 g03734117
Typical example of the schematic for the throttle switch
Not all connectors are shown. Refer to the Electrical Schematic for the application.
Illustration 3 g02723018
Typical view of the pin locations on the P1 connector for the throttle switch
(55) Throttle switch signal
(77) Throttle switch ground
Table 2
Troubleshooting Test Steps Values Results
1. Inspect Electrical Connectors and Wiring
A. Thoroughly inspect the terminal connections on the P1/J1 connector.
B. Thoroughly inspect the connector for the throttle switch.
C. Refer to Troubleshooting, "Electrical Connectors - Inspect".
D. Perform a 30 N (6.7 lb) pull test on each of the wires in the connectors that are associated with the throttle switch.
E. Check the harness for abrasions and for pinch points from the switch back to the ECM.
Damaged wire or connector
Result: A damaged wire or damaged connector was not found.
Proceed to Test Step 2.
Result: A damaged wire or damaged connector was found.
Repair: Repair the damaged wire or the damaged connector.
Use the electronic service tool to clear all logged diagnostic codes. Verify that the repair eliminates the fault.
2. Check for Active or Recently Logged Diagnostic Codes
A. Turn the keyswitch to the OFF position.
B. Connect the electronic service tool to the diagnostic connector.
C. Turn the keyswitch to the ON position. Do not start the engine.
D. Check for active diagnostic codes with the throttle switch in each position. Wait at least 10 seconds with the switch in each position for activation of the diagnostic codes.
Diagnostic Trouble Codes
Result: