ELEMENT 6H6095 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of all maintenance including the following procedures: all adjustments , the use of proper lubricants, fluids, filters and the installation of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption , service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Products that operate in severe operating conditions may require more frequent maintenance.When Required
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Generator - Dry
Generator Bearing - Inspect
Generator Set Alignment - Check
Generator Winding - Test
Rotating Rectifier - Inspect/Test
Varistor - Inspect
Every Week
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Automatic Start/Stop - Inspect
Battery Charger - Check
Battery Electrolyte Level - Check
Control Panel - Inspect/Test
Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Check/Clean
Engine Oil Level - Check
Fuel Filter Differential Pressure - Check
Generator - Inspect
Generator Bearing Temperature - Test/Record
Generator Lead - Check
Generator Load - Check
Jacket Water Heater - Check
Power Factor - Check
Space Heater - Test
Standby Generator Set Maintenance Recommendations
Stator Winding Temperature - Test
Voltage and Frequency - Check
Walk-Around Inspection
Every Year
Actuator Control Linkage - Lubricate
Air Starting Motor Lubricator Bowl - Clean
Alternator - Inspect
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 2) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Crankcase Blowby - Test/Record
Crankshaft Vibration Damper - Inspect
Cylinder Pressure - Test/Record
Engine - Clean
Engine Air Cleaner Element - Replace
Engine Crankcase Breather - Clean
Engine Mounts - Inspect
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Performance - Test
Engine Protective Devices - Check
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Exhaust Piping - Check
Gas Pressure Regulator - Test
Gas Pressure Regulator Condensation - Drain
Generator Bearing - Lubricate
Generator Set - Test
Generator Set Vibration - Test/Record
Generator Winding Insulation - Test
Hoses and Clamps - Inspect/Replace
Ignition System Timing - Check/Adjust
Ignition System Transformer Resistance - Test
Inlet Air System - Check
Radiator - Clean
Spark Plugs - Inspect/Adjust/Replace
Speed Sensor - Clean/Inspect
Starting Motor - Inspect
Stator Lead - Check
Valve Stem Projection - Measure/Record
Varistor - Check
Varistor - Inspect
Water Pump - Inspect
Every 3 Years
Coolant (NGEC) - Change
Exhaust Bypass - Inspect
Hoses and Clamps - Inspect/Replace
Ignition System Transformer Resistance - Test
Rotating Rectifier - Check
Spark Plug Wires - Replace
Turbocharger - Inspect
(S/N: CRE1-Up; CRF1-Up; CTP1-Up; CTS1-Up) Commissioning
Generator Set Alignment - Check