ELEVATOR GP 9J0119 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     -     Loctite 263     -    Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Illustration 1 g01235844
Install nut (8) to lever (9) .
Apply Tooling (A) to the threads of lever (9) prior to installation.
Install lever (9) to pilot control valve (5). Lever (9) must be installed for a minimum of four turns.
Hold lever (9) in the orientation as shown and tighten nut (8) to a torque of 70 5 N m (51 4 lb ft).
Install grommet (10). Pull the wiring harness through the hole in pilot control valve (5) .
Install electrical connector (6). For instructions on servicing Deutsch connectors refer to Special Instruction, SEHS9615.
Illustration 2 g01260269
Install pilot control valve (5) to the machine.
Install four screws (7) .
Illustration 3 g01235830
Connect six hose assemblies (4) to pilot control valve (5) .
Connect electrical connector (6) .
Illustration 4 g01235827
Install cover (2). Install three bolts (3) and the washers to cover (2) .
Install cover (1) .
Fill the hydraulic tank with oil to the correct level. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check".End By:
Install the seat. Refer to Disassembly and Assembly, "Seat - Remove and Install".
Remove the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Remove and Install".