ENCLOSURE GP-GENERATOR 2297546 - Caterpillar

Table 1
Required Tools     A    
(1)     6V-8398 O-Ring Seals     2    
(2)     6V-8944 O-Ring Reducer     2    
(3)     6V-8557 Face Seal Nut     2    
(4)     5K-9090 O-Ring Seals     2    
(5)     8T-7813 Adapters     2    
(6)     7M-8485 O-Ring Seals     2    
(7)     9U-7446 Flange Adapters     2    
(8)     1P-4579 Flanges     4    
(9)     8T-8919 Bolts     8    
(10)     8T-4223 Hard Washers     8    
(11)     4J-0524 O-Ring Seals     2    
(12)     4C-9675 Hydraulic Flow Tester     1    
Illustration 1 g00541309
Install the rotational safety lock (11) on the Crusher.
Illustration 2 g00536078
Illustration 3 g00541310
Install tooling (A) to fittings (12) and (13) (S/N: 4DW, 4JW). Install tooling (B) to fittings (2) and (3) (S/N: 5BW, 5ZW).
Start the machine. Run the machine at high idle until the hydraulic oil reaches normal operating pressure.
Attempt to rotate the Crusher to the right. Record the reading on the pressure gauge. The gauge should increase to read 17000 kPa (2465 psi).
If the gauge does not reach 17000 kPa (2465 psi), then there is internal leakage within the hydraulic system. The relief valve setting may be lower than the specified value.
Attempt to rotate the Crusher to the left. Record the reading on the pressure gauge. The gauge should increase to read 17000 kPa (2465 psi).