ENCLOSURE GP 4562986 - Caterpillar

Front Light Fuse (5) - 10A
EMS Panel Fuse (6) - 10A
Hour Meter/Gauges Fuse (7) - 10A
Engine Starting Fuse (8) - 10A Circuit Breaker Reset - Push the button in to reset the circuit breaker. If working properly, button remains depressed. If button does not stay in, or comes out shortly after being reset, have appropriate electrical circuit checked.
Main Electrical System Reset (1)
Heater and Air Blower Motor Reset (2)Cutting Edges and End Bits
Replace if Worn or Damaged
1. Raise the dozer blade and place blocking under it. Lower the blade onto the blocking. Do not block the blade any higher than necessary to remove cutting edge or end bits.2. Remove bolts. Remove cutting edge and end bits.3. Clean all contact surfaces thoroughly.4. Turn cutting edge over and use the opposite edge, if it is not worn.5. Install a new cutting edge section, if both edges are worn.6. Repeat Steps 4 and 5 for the end bits.7. Install all bolts and tighten them to the specified torque. See the Torques for Ground Engaging Tool Bolts chart under Torque Specifications in the Maintenance Section of this manual for specified torque.8. Raise the dozer blade and remove the blocking. Lower the blade to the ground.9. After a few hours of operation, check all bolts for proper torque. Retorque any bolts as needed.Ripper Tips (If Equipped)
Replace if Worn or Damaged
Replace the ripper tip when worn close to shank. Too blunt of a tip does not penetrate properly.1. Raise the ripper and place blocking under it. Lower the ripper onto the blocking. Do not block the blade any higher than necessary to remove cutting edge or end bits.2. If the ripper tip is worn, drive the pin out. Remove the tip and the pin retainer.3. Clean the shank pin retainer and pin.4. Install the new tip and retainer.5. Install the pin in from the side opposite of the retainer.6. Raise the ripper and remove the support.7. Lower the ripper to the ground.Radiator
Clean or Replace Pressure Cap
1. Remove the coolant fill cap slowly to relieve any pressure.2. Inspect the cap for damage, deposits or foreign material. Clean the cap with a clean cloth or replace the cap if necessary.3. Install the cap.Clean Core
Compressed air, high pressure water or steam can be used to remove dust, leaves and general debris from the radiator core. Clean as required by condition of radiator.The use of compressed air is preferred.Refer to Know Your Cooling System, SEBD0518, for the complete procedure and instructions.Transmission System
Clean Scavenge Line Screens
The transmission oil screens should be removed and cleaned if the transmission oil pump fails, or if the transmission is disassembled for any reason. Drain the oil into a suitable container before removing any screens. 1. The bottom guard must be removed to gain access to the screens. 2. Remove the cover and main screen in the gear case.3. Remove the plug, seal, spring and screen from scavenge line on bottom of torque converter.4. Wash screens in clean nonflammable solvent.5. Inspect seals and replace