ENCLOSURE GP-GENERATOR 4869560 - Caterpillar

Actuation from the Operator's Station:
1. Stop the machine. 2. Pull the pin (1) in the actuator assembly. Pull out the lever (2) to actuate the system. The chemical agent should discharge.3. Dismount and move away from the machine to protect against possible personal injury due to the fire. Follow up with the portable extinguisher from the machine and other available fire fighting equipment. Summon the fire department.4. If the system did not discharge the agent, when actuated from the operator's station, actuate the system from the ground.Actuation from the Ground:
1. Pull the pin (1) in the actuator assembly at the front of the machine. Pull the lever (2). The chemical agent should discharge.2. To avoid possible personal injury due to the fire, move away from the machine. Use follow up fire fighting equipment.If the agent did not discharge, actuate the system at the agent cylinders, if it can be done safely.Discharging at the Agent Cylinders:
If operation of the actuator assembly does not cause agent discharge, the agent cylinders can be manually discharged at the cylinders. 1. Open the cover of the agent cylinder box. Pull the pin (1) in the hand operation lever on each agent cylinder. Pull the lever (2) on each cylinder to discharge the agent.2. To avoid possible personal injury due to the fire, move away from the machine. Use follow up fire fighting equipment.After Discharging the System:
The engine may be restarted immediately after agent discharge, if it is necessary to move the machine to a safe place.Before returning the machine to normal service, have any needed repairs made. Find and correct the cause of the fire. Have the fire suppression system actuator nitrogen cylinders and the agent cylinders recharged.The fire suppression agent is corrosive on certain types of surfaces. Clean the machine thoroughly, especially electrical components. Refer to the "Maintenance" Guide for cleaning.Fire Extinguisher
The machine is equipped with two 10 pound fire extinguishers. One is located in the operator's compartment behind the seat. The other is located at the right side of the machine. Check the extinguisher regularly as instructed on the extinguisher information plate.Travel Alarm
The travel alarm, located at the left rear of the upper structure, sounds to warn nearby personnel of machine movement. The alarm sounds anytime either the forward or reverse travel pedal is depressed. A switch at the back of the alarm adjusts the sound level.(1) HIGH sound level(2) LOW sound level(3) MEDIUM sound levelThe alarm is usually set at the HIGH level when shipped from the factory. To stop the alarm when it is not required, press the button at the top of the steering control lever.When the button is depressed momentarily while traveling, the alarm will sound for 10 seconds, then it will turn off.It will remain off until the machine is stopped and travel is resumed in either direction.Horn
Push down the button to sound the horn.Use the horn to signal or warn personnel.Emergency Exit
The rear cab window is used as an emergency exit. To remove the window