END-ADJUSTMENT YOKE 1K6555 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     138-7573     Link Bracket     1    
B     5P-3931     Anti-Seize Compound     -    Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Put identification marks on the bellows for alignment and orientation during installation of the bellows.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01293522
The ends of the bellows are very sharp. Injury could occur if the bellows are not handled properly. Handle the bellows by the convolutions.
Note: Refer to Special Instruction, REHS1728, "Application Guideline for the Bellows" for additional information on handling the bellows.
Use Tooling (A) and a suitable lifting device in order to install turbocharger (11) and bellows (12) . The weight of turbocharger (11) and bellows (12) is approximately 34 kg (75 lb).
Apply Tooling (B) to the threads of bolts (10) . Install bolts (10) . Tighten bolts (10) to a torque of 55 5 N m (41 4 lb ft).Note: Discard the nuts after use. Use new nuts for installation.
Apply Tooling (B) to the threads of the studs. Install nuts (9) . Tighten nuts (9) to a torque of 55 5 N m (41 4 lb ft).
Apply Tooling (B) to the threads of clamp (8) . Connect clamp (8) . Tighten clamp (8) to a torque of 12 2 N m (106 18 lb in).
Illustration 2 g01293508
The ends of the bellows are very sharp. Injury could occur if the bellows are not handled properly. Handle the bellows by the convolutions.
Note: Refer to Special Instruction, REHS1728, "Application Guideline for the Bellows" for additional information on handling the bellows.
Apply Tooling (B) to the threads of clamp (7) . Connect clamp (7) . Tighten clamp (7) to a torque of 12 2 N m (106 18 lb in).
Install elbow (5) and the bellows.
Apply Tooling (B) to the threads of clamp (6) . Connect clamp (6) . Tighten clamp (6) to a torque of 12 2 N m (106 18 lb in).
Apply Tooling (B) to the threads of clamp (4) . Connect clamp (4) . Tighten clamp (4) to a torque of 12 2 N m (106 18 lb in).
Connect tube assembly (3) . Connect tube assembly (2) .