END BIT 2D7997 - Caterpillar

The OCP have an internal real-time clock that is used for time-stamping events and programmable cycle timer. After the internal battery fails, the real-time clock will continue to keep time only when the control battery power is connected. If the control battery power is disconnected, then the real-time clock must be reprogrammed when the OCP is powered up again.Changing the Time/Date
The OCP clock allows the time/date to be modified. Changing the time/date will change the timestamp on all future events, but not for existing events. (For example, an event that has occurred previously will still show the same first time/date. However, if the event occurs again after the time/date has been adjusted, the last time/date will reflect the change.)This procedure must be performed on the OCP display. This procedure cannot be done using the Cat ET. In order to update time/date, level 1 access is required.Perform the following steps in order to change the date format.
Illustration 1 g02137854
From the "MAIN MENU", press the arrow keys in order to highlight the "CONFIGURE" menu. Press the "OK" key.
Illustration 2 g03008057
Press the arrow keys in order to highlight "TIME/DATE". Press the"OK" key in order to select "TIME/DATE".
Illustration 3 g03008058
The "SET TIME/DATE" dialog will appear. The currently programmed time is displayed. Press the"OK" key twice in order to begin to edit the time.
Press the left key or the right key to select a digit. Press the up key or the down key to change the selected digits. Press the "OK" key to accept the changes. Press the escape key to cancel the changes. Change the Date
Use the following steps to change the date. Begin at the "SET TIME/DATE" screen.
Illustration 4 g03008058
Press the escape key again to return to the "SET TIME/DATE" screen.
Illustration 5 g02309674
Use the navigation keys to place the selection box around the date. Note: Alternately, pressing the "DATE" softkey from the "Set Time/Date" screen will open the set date dialog.
Press the "OK" key to enter the editor while the current date is selected.
Press the left key or the right key to select a digit. Press the up key or the down key to change the selected digits. Press the "OK" key to accept the changes. Press the escape key to cancel the changes. Change the Date Format
The data format can be set to either display in the form Month/Day/Year or the form Day/Month/Year. This procedure must be performed on the OCP display. This procedure cannot be performed with Cat ET.Note: The preference does not affect operation of the OCP or the data as viewed in Cat ET. The preference only affects how the date is displayed on the OCP display and the format of the event time stamps.Use the following steps to change the date format.
Illustration 6 g02137854
From the "MAIN MENU", press the arrow keys in order to highlight the "CONFIGURE" menu. Press the "OK" key.
Illustration 7 g03008057
Press the arrow keys in order to highlight "TIME/DATE". Press the"OK" key in order to select "TIME/DATE".
Illustration 8 g02309714
The "SET TIME/DATE" dialog will appear. Press the arrow keys in order to