END 3D2974 - Caterpillar

Illustration 24 g01192330
Install ring seal (21) on piston (20) .
Illustration 25 g01290146
Use Tooling (B) and a suitable lifting device in order to reposition carrier assembly (18) . The weight of carrier assembly (18) is approximately 68 kg (150 lb).
Illustration 26 g01290279
Install piston (20) .
Illustration 27 g01290280
Illustration 28 g01290139
Install hub (19) .
Install plates (17) and discs (16) .
Illustration 29 g01290138
Install plate (15) , retainers (14) , and bolts (13) . Tighten bolts (13) to a torque of 50 7 N m (37 5 lb ft).
Illustration 30 g01290135
Use Tooling (F) in order to install bearing (12) on hub (11) .
Lower the temperature of hub (11) and install hub (11) .
Illustration 31 g01290134
Reposition turbine (10) and install bolts (9) . Tighten bolts (9) to a torque of 80 10 N m (60 7 lb ft).
Illustration 32 g01290287
Align the detents on race (28) with the dowels in the carrier and install race (28) .
Illustration 33 g01290297
Install Tooling (D) , Tooling (B) , and a suitable lifting device to the carrier and turbine assembly (7) . The weight of carrier and turbine assembly (7) is approximately 141 kg (310 lb). Use Tooling (B) and the suitable lifting device to install the carrier and turbine assembly (7) .
Install bolts (8) . Tighten bolts (8) to a torque of 240 25 N m (177 18 lb ft).
Remove Tooling (D) and Tooling (B) .
Illustration 34 g01290110
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install washer (6) , plate (5) , and bolts (4) . Tighten bolts (4) to a torque of 120 15 N m (89 11 lb ft).
Illustration 35 g01290108
Install pilot (3) and bolts (2) . Tighten bolts (2) to a torque of 120 15 N m (89 11 lb ft).
Illustration 36 g01290107
Use Tooling (B) and a suitable lifting device to remove torque converter (1) from Tooling (A) . The weight of torque converter (1) is approximately 340 kg (750 lb).End By: Install the torque converter. Refer to Disassembly and Assembly, "Torque Converter - Install".