END BIT R.H. HOT CUPPED 1.575" THICK 3G8279 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of all maintenance which includes the following items: performing all adjustments, using proper lubricants, fluids, and filters and replacing old components with new components due to normal wear and aging .Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Choose the interval that occurs first in order to determine the correct maintenance interval: fuel consumption, service hours and calendar time . Products that operate in severe operating conditions may require more frequent maintenance. All of the following will affect the oil change interval: operating conditions, fuel type, oil type and size of the oil sump . Scheduled oil sampling analyzes used oil in order to determine if the oil change interval is suitable for your specific engine. Refer to this Operation and Maintenance Manual, "Engine Oil and Filter - Change" in order to determine the oil change interval that is suitable for your specific engine.To determine the maintenance intervals for the overhauls, refer to this Operation and Maintenance Manual, "Maintenance Recommendations" .When Required
Coolant - Change
Coolant Extender (ELC) - Add
Fuel System - Prime
Maintenance Recommendations
Daily
Coolant Level - Check
Engine Oil Filter Differential Pressure - Check
Engine Oil Level - Check
Fuel Filter Differential Pressure - Check
Walk-Around Inspection
Initial 250 Service Hours
Engine Valve Lash - Check
Fuel Injector - Check
Every 250 Service Hours
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Engine Oil Sample - Obtain
Hoses and Clamps - Inspect/Replace
Initial 500 Service Hours (or at first oil change)
Engine Speed/Timing Sensor - Clean/Inspect
Every 500 Service Hours
Engine Oil and Filter - Change
Fuel System Primary Filter - Clean/Inspect/Replace
Fuel System Secondary Filter - Replace
Every 1000 Service Hours
Coolant Sample (Level 2) - Obtain
Engine - Clean
Engine Crankcase Breather - Clean
Engine Protective Devices - Check
Every 2000 Service Hours
Crankshaft Vibration Damper - Inspect
Driven Equipment - Check
Engine Mounts - Inspect
Turbocharger - Inspect
Every 4000 Service Hours
Engine Valve Lash - Check
Fuel Injector - Check
Every 6000 Service Hours or 6 Years
Coolant Temperature Regulator - Replace
Starting Motor - Inspect
Water Pump - Inspect
Every 1 245 400 L (329 000 US gal) of Fuel or 9000 Service Hours
Overhaul (Top End)
Every 2 490 800 L (658 000 US gal) of Fuel or 18 000 Service Hours
Overhaul (Major)
Overhaul
Aftercooler Core - Inspect/Clean/Test
Overhaul Considerations