ENGINE AR 0R2875 - Caterpillar

This safety message is located inside the left front compartment on the engine air filter.
Explosion hazard! Do not use ether! This machine is equipped with an air inlet heater. Using ether can create explosions or fires that can cause personal injury or death. Read and follow the starting procedure in the Operation and Maintenance Manual.
Refer to Operation and Maintenance Manual, "Engine Starting" for further information.(10) Relieve Hydraulic Tank PressureThis safety message is located on top of the hydraulic tank.
Illustration 12 g01067344
HYDRAULIC TANKRELIEVE TANK PRESSURE WITH ENGINE OFF BY REMOVING CAP SLOWLY TO PREVENT BURNS FROM HOT OIL.
(11) Pressurized SystemThis safety message is located on top of the radiator, next to the filler cap.
Illustration 13 g01067344
Pressurized system! Hot coolant can cause serious burns, injury or death. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Read and understand the Operation and Maintenance Manual before performing any cooling system maintenance.
Refer to Operation and Maintenance Manual, "Cooling System Coolant Level - Check" for further information.(12) Crushing HazardThis safety message is located on the rear of each side of the machine. This safety message is also located on each side of the counterweight.
Illustration 14 g01067376
Machine swings. Stay back. Crushing hazard could cause serious injury or death.
(13) Jump Start CablesThis safety message is located inside the left front compartment.
Illustration 15 g01067366
Explosion Hazard! Improper jumper cable connections can cause an explosion resulting in serious injury or death. Batteries may be located in separate compartments. Refer to the Operation and Maintenance Manual for the correct jump starting procedure.
Refer to Operation and Maintenance Manual, "Engine Starting with Jump Start Cables" for further information.(14) High Pressure CylinderThis safety message is positioned on the track adjuster on both sides of the machine.
Illustration 16 g01076729
High Pressure Cylinder. Do not remove any parts from the cylinder until all of the pressure has been relieved. This will prevent possible personal injury or death.
(15) High Pressure Gas
Illustration 17 g01067549This safety message is located on the accumulator in the right back compartment.
This system contains high pressure gas. Failure to follow the instructions and warnings could cause an explosion, resulting in possible injury or death.Do not expose to fire. Do not weld. Do not drill. Relieve pressure before discharging.See Operation and Maintenance Manual for charging and discharging. See your Caterpillar Dealer for tools and detailed information.