ENGINE AR 1321981 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
ZZ     6V-9507     Face Seal Plug (9/16 - 18 THD)     1    
6V-9828 Cap Assembly (9/16 - 18 THD)     1    
6V-9509 Face Seal Plug (13/16 - 16 THD)     5    
6V-9830 Cap Assembly (13/16 - 16 THD)     5    Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This will help to prevent fluid loss and this will help to keep contaminants from entering the system.
Illustration 1 g00942050
Illustration 2 g00942051
Disconnect hose assemblies (3) from metering pump (2) .
Support metering pump (2). Remove bolts (4) and remove plate (1) and metering pump (2) .
Illustration 3 g00803551
Remove bolts (5) and remove plate (1) from metering pump (2) .Installation Procedure
Illustration 4 g00803551
Position plate (1) on metering pump (2) and install bolts (5) .
Illustration 5 g00942050
Illustration 6 g00942051
Position plate (1) and metering pump (2) against the bottom of the operator platform or the bottom of the cab. Install bolts (4) .
Connect hose assemblies (3) to metering pump (2) .End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".