1399773 ENGINE AR-COMPLETE Caterpillar parts C-10 ENGINE
Alternative (cross code) number:
Buy ENGINE AR-COMPLETE 1399773 Caterpillar genuine, new aftermarket tractor parts with delivery
Compatible equipment models: 1399773:
TRUCK ENGINE C-10 Caterpillar
Illustration 1 g03485478
Under the "Utilities" menu, select "Preferences" (Illustration 1).
Select "Modify" to change connection settings in Cat ET.
Illustration 2 g03485516
Under the "Communications" tab, change the connection type to "Ethernet Direct Connection" (Illustration 2).
Illustration 3 g03485581
Select the "Network Adapter Connection" that supports the "Ethernet Direct Connection" (Illustration 3).
Illustration 4 g03485596
Based on the change of Communication Protocol, Cat ET might attempt to reconnect. If the screen shown in Illustration 4 appears, press the "Yes" button.
Illustration 5 g03485758
When Cat ET reconnects, the program will attempt to detect an ECM using "IP Data Link" (Illustration 5).
Illustration 6 g03485796
When the ECM is detected, select the Flash File and initiate the Flash process (Illustration 6).Note: Wait until Cat ET shows 100% completed, even if the Display appears to be working during Flashing.
Illustration 7 g03485900
If Cat ET provides a warning that the Operating System will be changed, press "OK" (Illustration 7).
During the Flashing process, the Display will show the following:
Illustration 8 g03487493
WAIT until the Flash Process has completed.
Illustration 9 g03487401
Illustration 10 g06014093
Illustration 11 g03494458
Wait until "Flash Completed Successfully!" displays. Press "Cat ET" (Illustration 11).
Illustration 12 g03494483
After Flashing, change the Communication settings back to "Comm Adapter 3" (or "Comm Adapter 2"). See Illustration 12.
Connect to Cat ET.
Go to Display > Configurations.
Illustration 13 g03494716
Verify that the Product ID matches the Machine Product ID. If the Product ID does not match the Machine Product ID, change the cycle power to the machine so the Display can re-request Product ID.Note: This machine cannot manually change product ID configuration. Changing the product ID configuration is supported in the ECM summary screen in ET, but not in the configuration area.Note: Illustration 13 is a sample screenshot for D9TREX00301. New Flashing will be different.Flashing Example
The following is an example of the approximate numbers and timing recorded during a Flash (with no bus traffic). Always wait until the Flash Process has completed.Note: Data Link traffic and timing will vary between machines.
Cat ET shows 18% at 16 seconds.
Cat ET shows 45% at approximately 26 seconds.
Reboot at 38 seconds.
Eboot erasing at 48 seconds.
Eboot loading done at 1:04.
Erasing NOR at 1:05.
Erasing NOR OS space ends at 2:37.
Programming OS starts at 2:38.
Programming OS ends at 6:14.
Display has rebooted, but is older cab file at 6:30.
Cat ET shows 50% at 6:38.
Cat ET shows 90% at 6:45.
Cab file extraction at 7:07.
Reboots and shows new cab file at 8:09.
Cat ET shows 100% at 8:19.