AVSPARE.COM
parts catalog

ENGINE AR-COMPLETE 1399775 - Caterpillar



1399775 ENGINE AR-COMPLETE Caterpillar parts C-10 ENGINE
Rating:
26
Alternative (cross code) number:
CA1399775
139-9775
1399775
Caterpillar 1399775 ENGINE AR-COMPLETE

Buy ENGINE AR-COMPLETE 1399775 Caterpillar genuine, new aftermarket tractor parts with delivery
TRUCK ENGINE,

Compatible equipment models: 1399775:

TRUCK ENGINE  C-10   Caterpillar
  For full view, you need register

Information:

Rubber toric seals and all surfaces in contact with them must be clean and dry at assembly. Put a thin layer of oil on the surfaces of the metal seals that are in contact just before installation. Put lubricant on all other seals at assembly.(1) Torque for nut ... 407 54 N m (300 40 lb ft)Torque for bolts that hold the nut lock in place ... 244 27 N m (180 20 lb ft)(2) Torque for bolts ... 57 8 N m (42 5 lb ft)(3) Distance between face of flange and shoulder of pinion ... 3.0 0.8 mm (.12 .03 in)After the flange and pinion have been pushed together with a force of ... 134 to 178 kN (15 to 20 ton)(4) Torque for bolts ... 115 14 N m (85 10 lb ft)(5) Distance between face of sprocket and the spline shoulder of the hub ... 3.0 1.5 mm (.12 .06 in)After the sprocket has been pushed on the hub with a force of ... 178 to 223 kN (20 to 25 ton)(6) Torque for nut ... 474 68 N m (350 50 lb ft)(7) Tighten nuts to ... 81 7 N m (60 5 lb ft)Then tighten nut an additional ... 120°After nuts have been turned an additional 120°, torque for nuts must be 306 N m (225 lb ft) minimum.(8) Torque for nut [after shaft has been installed to distance shown in (10)] ... 746 68 N m (550 50 lb ft)(9) Torque for bolts ... 135 14 N m (100 10 lb ft)Make certain that the face at the front and rear ends of this plate is not more than 0.10 mm (.004 in) from the face of the steering clutch case.(10) Distance for installation of shaft (from face of holder to line of separation of steering clutch case and final drive cover) ... 241.30 1.57 mm (9.500 .062 in)(11) See Adjustment Of Final Drive Bearings(12) Torque for nut ... 474 68 N m (350 50 lb ft)(13) Maximum amount the sprocket shaft can be bent is ... 3.2 mm (.125 in).Measure with a square with the sprocket shaft installed in the case. Measure at four places (every 90°).

Caterpillar SIS machinery equipment:

Caterpillar SIS


Parts engine Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.