AVSPARE.COM
parts catalog

ENGINE AR-COMPLETE 1399814 - Caterpillar



1399814 ENGINE AR-COMPLETE Caterpillar parts 3126 ENGINE
Rating:
24
Alternative (cross code) number:
CA1399814
139-9814
1399814
Caterpillar 1399814 ENGINE AR-COMPLETE

Buy ENGINE AR-COMPLETE 1399814 Caterpillar genuine, new aftermarket tractor parts with delivery
TRUCK ENGINE,

Compatible equipment models: 1399814:

TRUCK ENGINE  3126   Caterpillar
  For full view, you need register

Information:


At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Note: In order to access the areas required to perform this procedure, a portable access system (ladder, stair assembly, man lift, or other portable access system) that is suitable and compliant to local regulations may be necessary.When a Caterpillar Extended Life Coolant (ELC) is used, an Extender must be added to the cooling system. Use a 8T-526 Coolant Test Kit to check the concentration of the coolant.Refer to the Special Publication, SEBU6250, "Caterpillar Machines Fluids Recommendations", "Cooling System Specifications" for more information about the addition of Extender.
Topping off or mixing Cat ELC with other products that do not meet Caterpillar EC-1 specifications reduces the effectiveness of the coolant, shortens coolant service life, and may cause premature wear to components.Use only Caterpillar products or commercial products that have passed the Caterpillar EC-1 specification for pre-mixed or concentrate coolants. Use only Extender with Cat ELC.Failure to follow these recommendations can result in shortened cooling system component life.
Stop the engine. Allow the cooling system to completely cool.
Open the engine compartment.
Illustration 1 g03774439
Slowly loosen the cooling system pressure cap in order to relieve system pressure. Remove the cooling system pressure cap.
If necessary, drain enough coolant from the radiator in order to allow the addition of the Extender.
Add the recommended amount of extender to the coolant system. Refer to the Special Publication, SEBU6250, "Caterpillar Machines Fluids Recommendations", "Cooling System Specifications" for the proper amount.
Illustration 2 g03774993
Maintain the coolant level between the indicated lines.
Inspect the gasket on the cooling system pressure cap. Replace the cooling system pressure cap if the gasket is damaged.
Install the cooling system pressure cap.
Close the engine compartment.

Caterpillar SIS machinery equipment:

Caterpillar SIS


Parts engine Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.