AVSPARE.COM
parts catalog

ENGINE AR-COMPLETE 1399879 - Caterpillar



1399879 ENGINE AR-COMPLETE Caterpillar parts 3406E ENGINE
Rating:
85
Alternative (cross code) number:
CA1399879
139-9879
1399879
Caterpillar 1399879 ENGINE AR-COMPLETE

Buy ENGINE AR-COMPLETE 1399879 Caterpillar genuine, new aftermarket tractor parts with delivery
TRUCK ENGINE,

Compatible equipment models: 1399879:

TRUCK ENGINE  3406E   Caterpillar
  For full view, you need register

Information:

(1) Maximum permissible temperature of the gear for installation on the camshaft (do not use a torch) ... 315°C (600°F)(2) Tight fit between the gear and camshaft ... 0.037 to 0.123 mm (.0016 to .0048 in.)(3) Diameter of the surfaces (journals) for the camshaft bearings (new) ... 69.850 0.013 mm (2.7500 .0005 in.) Bore in front bearing for the camshaft (after assembly) ... 69.969 0.048 mm (2.7547 .0019 in.)Bore in the other six bearings for the camshaft (after assembly) ... 69.982 0.061 mm (2.7552 .0024 in.)(4) Thickness of thrust plate (new) ... 4.65 0.03 mm (.183 .001 in.) End play of the camshaft ... 0.10 to 0.26 mm (.004 to .010 in.) (5) Height of camshaft lobes. To find lobe height, use the procedure that follows:A. Measure camshaft lobe height (5).B. Measure base circle (7).C. Subtract base circle (STEP B) from lobe height (STEP A). The difference is actual lobe lift (6).D. Specified camshaft lobe lift (6) is: a. Exhaust lobe ... 10.211 mm (.4020 in.)b. Intake lobe ... 10.211 mm (.4020 in.)Minimum permissible difference between actual lobe lift (STEP C) and specified lobe lift (STEP D) is 0.13 mm (.005 in.)Intake Valve Timing
1. Check the No. 1 intake valve clearance with the engine stopped. The valve clearance must be 0.30 to 0.46 mm (.012 to .018 in.). If the valve clearance is not in this range, adjust the clearance to 0.38 mm (.015 in.)2. Mark Top Center Position of the crankshaft on the vibration damper or pulley.3. Use a dial indicator to measure the intake valve movement.4. Rotate the crankshaft in the direction of normal engine rotation. Stop when the intake valve is 1.91 mm (.075 in.) off its seat in the opening sequence. At this point the crankshaft Top Center Position Mark must be in position as follows: Engines with 8N9245 Camshaft Assembly ... 3 2° After Top Center

Caterpillar SIS machinery equipment:

Caterpillar SIS


Parts engine Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.