ENGINE AR 1483591 - Caterpillar

Illustration 1 g00101648
(A) Stick. (B) Bucket. Note: Assemble this linkage on the machine by rotating the rod end of the bucket cylinder and by positioning the grease fitting away from the stick. Coat all of the bores for pins with lubricant. (1) 087-5845 Pin : Diameter after plating ... 79.85 0.04 mm (3.144 .002 inch) Minimum thickness for plating ... 0.013 mm (.0005 inch) (2) 4I-0453 Bearing : Quantity ... 2 Outside diameter ... 95.180 0.013 mm (3.7472 0.0005 inch) Inside diameter ... 80.25 0.02 mm (3.159 0.001 inch) Install the bearing in the bearing bore. ... 8.0 0.8 mm (.32 .03 inch) (3) Lubricate the sealing lip slightly with the lubricant that is being sealed. (4) 087-5806 Pin : Diameter after plating ... 69.85 0.04 mm (2.750 0.002 inch) Minimum thickness for plating ... 0.013 mm (.0005 inch) (5) 087-5805 Pin : Quantity ... 2 Diameter after plating ... 79.85 0.04 mm (3.144 0.002 inch) Minimum thickness for plating ... 0.013 mm (.0005 inch) (6) 7y-3428 Bearing : Quantity ... 2 Outside diameter ... 95.180 0.013 mm (3.7472 0.0005 inch) Inside diameter ... 80.25 0.02 mm (3.160 .001 inch) Install the bearing in the bearing bore. ... 7.5 0.2 mm (0.30 0.01 inch) (7) Position the four nuts past the end of the four bolts. ... 0.5 mm (.02 inch) (8) Torque for four nuts (8) against four nuts (7) ... 200 40 N m (150 30 lb ft) (9) 093-0115 Shim thickness ... 2.0 mm (.08 inch)Note: Locate the above shim next to the power link. Locate the shims below next to the idler link. (10) Use necessary shims to adjust maximum lateral clearance. Maximum clearance ... 0.8 mm (.03 inch) 133-2429 Shim thickness ... 0.5 mm (.02 inch) 133-2436 Shim thickness ... 1.0 mm (.04 inch) 133-2446 Shim thickness ... 1.6 mm (.06 inch) 133-2476 Shim thickness ... 2.0 mm (.08 inch)