ENGINE AR-COMPLETE 1561958 - Caterpillar

Select "Engine Spd Sw" (5).
Illustration 4 g06148286
Select "ECO" (6) or "Low" (7).
Illustration 5 g06144108
Move engine start switch (8) to the OFF position.
Illustration 6 g03247326
Apply Tool (G) on the NPT side of each Tool (A). Install one Tool (A) in each side of Tool (B).
Assemble Tool (C) and Tool (D). Connect one Tool (D) to each Tool (A) on Tool (B).
Assemble Tool (E) and Tool (F). Make two sets of this tool assembly. Connect Tool (E) from one of tool assemblies to Tool (C) on each side of the flowmeter.
Illustration 7 g06172750
Left Front Propel Motor Shown
Disconnect brake supply hose assembly (9) from all four motors. Use Tool (M) to cap the port. Use Tool (N) to plug the hose.
If the propel motor on the right side of the rear drum or on the left side of the front drum is being tested, go to Step 11. If the propel motor on the left side of the rear drum or on the right side of the front drum is being tested, go to Step 17.
Illustration 8 g06172756
Loosen clamp (11). Remove case drain hose (13) from adapter (10).
Remove adapter (10) from adapter (12). Leave adapter (12) in the motor.
Reconnect case drain hose (13) to adapter (10). Tighten clamp (11) on the case drain hose and the adapter.
Illustration 9 g06172758
Install Tool (H) in adapter (12) in the motor. Install Tool (E) from inlet side of Tool (B) onto Tool (H).
Illustration 10 g06172760
Install Tool (J) on adapter (10). Install Tool (E) from outlet side of Tool (B) onto Tool (J).
Go to Step 23.
Illustration 11 g06172907
Loosen clamp (15). Remove hose (14) from adapter (16). Remove the adapter from the propel motor.
Reconnect hose (14) to adapter (16). Tighten clamp (15) on the hose and the adapter.
Illustration 12 g06172915
Install Tool (K) in the propel motor.
Install Tool (E) from inlet side of Tool (B) onto Tool (K).
Install Tool (L) onto adapter (16).
Install Tool (E) from outlet side of Tool (B) onto Tool (L).
Move engine start switch (8) to the START position. Release the switch when the engine starts.
Place the engine at high idle.
Operate the hydraulic system until the oil temperature reaches the test temperature of 45 °C (113 °F).
Move parking brake switch (2) to the OFF position.
Illustration 13 g06172941
Use speed control switches (17) to set the propel speed to 50 percent.Note: Two things indicate when the propel speed is set to 50 percent. First, "Speed Control % 50" will appear on the display. Second, four LEDs next to speed control switches (17) will be illuminated.
Modulate propel lever (1) forward until flow is registered. (approximately one half of