ENGINE AR 1626206 - Caterpillar

Elevator Speed Reducer - Check/Lubricate
Illustration 1 g00741394
The elevator speed reducer (1) is located at the top of the elevator. The elevator speed reducer is on the left side of the elevator.
Park the machine on level ground. Lower the bowl. Apply the parking brake.
Clean the area around the level plug (3) .
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Remove the level plug (3). Oil should drip out of the filler hole. Add oil if oil is needed. Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for further information.
Remove filler plug (2) in order to add oil.
Clean the filler plug and the level plug. Install the filler plug and the level plug.Elevator Speed Reducer Oil - Change
Illustration 2 g00741394
Illustration 3 g00741404
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
The elevator speed reducer (1) is located at the top of the elevator. The elevator speed reducer is on the left side of the elevator.
Park the machine on level ground. Lower the bowl. Apply the parking brake.
Clean the area around the filler plug (2) and the level plug (3) .
Clean the area around the drain plug (4). Remove the drain plug.
Allow the oil to drain into a suitable container.
Clean the drain plug. Install the drain plug.
Remove filler plug (2) and the level plug (3). Fill the gear case with oil. Refer to Operation and Maintenance Manual, "Refill Capacities" for further information. Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for further information. Oil should drip out of the hole for the level plug (3) when the gear case is full of oil.
Clean the filler plug and the level plug. Install the filler plug and the level plug.