ENGINE AR-COMPLETE 1861732 - Caterpillar

Personal injury or death can result from sudden work tool movement.Sudden movement of the work tool can cause injury to persons near the work tool.To prevent injury or death, make sure that the area around the work tool is clear of personnel and obstructions before operating the work tool.
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.
Required Parts
Table 1
533-1782 Auxiliary Control Ar (Tool Control) (- 02)
Qty Part No. Description Media
(1) 533-1781 Film Gp -
(1) 489-2976 Front Lines Gp M0081905
(1) 490-2713 Chassis Wiring Gp M0081911
(1) 490-2714 Valve Wiring Gp M0081913
(1) 532-0153 Valve Gp M0081915
(1) 492-2066 Front Lines Gp M0081917
(1) 491-6992 Oil Cooler Lines Gp M0081919
(1)(1) 557-7502 Pilot Lines Gp M0091492
(1) 533-1276 Film -
Standard Removal
(A) 492-0412 Pilot Lines Gp -
(B) 491-6991 Oil Cooler Lines Gp -
(1) FOR USE WITH EXISTING HEAVY LIFT CIRCUIT.
Illustration 2 g06225780
Standard removal parts shown in red.
Remove pilot lines group (A) and oil cooler lines group (B) before installing this kit on your machine.Installation of the Films
Illustration 3 g06317509
533-1781 Film Gp
(1) 250-8054 Hammer Film
(2) 260-6941 Controls Film
Illustration 4 g06317508
(3) 533-1276 FilmInstallation Section
Illustration 5 g06246079
Removal of oil tank (C) and fuel tank (D).
Note: For Tool Control -When installing the main valves, the oil tank (C) and fuel tank (D) must be drained and removed from the machine due to minimal clearance for the bolt heads on the main valve and the tanks.Reference: Disassembly and Assembly, M0080364Tuning Section
Reference: M0081160, "320 GC, 320 and 323 Excavators Tool Control System"Systems Operation Testing and Adjusting, Process for setting Up the Work Tool.