1929412 ENGINE AR-COMPLETE Caterpillar parts
C-15
Rating:
Alternative (cross code) number:
CA1929412
192-9412
1929412
CA1929412
192-9412
1929412
TRUCK ENGINE,
Compatible equipment models: 1929412:
For full view, you need register
Information:
Engine: Machine with Mechanical Unit Injection
3126 Engine: Machine with Mechanical Unit Injection
3116 Engine: Machine with Mechanical Unit Injection
3114Warranty Category: GFeatures/Benefits
The reamer shims are used in order to control depth of the injector sleeve reaming operation. The reamer sleeves will allow only 0.25 mm (.010 inch) of material to be removed during each reaming. The reamer shims prevent the sleeve from being too deeply reamed. The shims provide a positive stop at the end of each reaming operation. The reamer shims minimize reamer chatter.Procedure
Install four shims between the 4C-8713 reamer shanks (2) and the bushing (3) .
The sleeve is reamed until the reamer shank contacts the shim.
Examine the injector sleeve after reaming.
If the injector sleeve is not clean, remove an additional shim.
Remove one shim (1) at a time.
Repeat the procedure until the proper seat finish is obtained. Specifications/Technical Information
Illustration 1 g00702594
(1) 170-9227 Reamer Shims (2) 4C-8713 Reamer Shank (3) 4C-8714 Bushing Thickness ... 0.25 mm (.010 inch)Number of shims per packet ... 4Reference
Refer to Tool Operating Manual, NEHS0675, "Using the 143-2099 Sleeve Replacement Tool Group ".
3126 Engine: Machine with Mechanical Unit Injection
3116 Engine: Machine with Mechanical Unit Injection
3114Warranty Category: GFeatures/Benefits
The reamer shims are used in order to control depth of the injector sleeve reaming operation. The reamer sleeves will allow only 0.25 mm (.010 inch) of material to be removed during each reaming. The reamer shims prevent the sleeve from being too deeply reamed. The shims provide a positive stop at the end of each reaming operation. The reamer shims minimize reamer chatter.Procedure
Install four shims between the 4C-8713 reamer shanks (2) and the bushing (3) .
The sleeve is reamed until the reamer shank contacts the shim.
Examine the injector sleeve after reaming.
If the injector sleeve is not clean, remove an additional shim.
Remove one shim (1) at a time.
Repeat the procedure until the proper seat finish is obtained. Specifications/Technical Information
Illustration 1 g00702594
(1) 170-9227 Reamer Shims (2) 4C-8713 Reamer Shank (3) 4C-8714 Bushing Thickness ... 0.25 mm (.010 inch)Number of shims per packet ... 4Reference
Refer to Tool Operating Manual, NEHS0675, "Using the 143-2099 Sleeve Replacement Tool Group ".