ENGINE AR 1N4400 - Caterpillar

Illustration 11 g00690430
Install clamp (24) for the boot.
Install bracket (26).
Apply Tooling (A) and then apply Tooling (B) to the threads of bolt (25).
Install bolt (25). Tighten bolt (25) to a torque of 25 2.5 N m (18 2 lb ft).
Illustration 12 g00690428
Install handle (23) and dowel (22) to the steering pilot valve.
Illustration 13 g00690427
Install two connecting links (21).
Illustration 14 g00690391
Install boot (20) to the steering pilot valve (7).
Illustration 15 g00690390
Install base (19) to the steering pilot valve.
Install set screw (18). Repeat for the other side.
Illustration 16 g00690387
Install locknut (17). Tighten locknut (17) to a torque of 25 5 N m (18.5 3.5 lb ft).
Illustration 17 g00690383
Install eight wires to connector (15). For instructions on servicing refer to Deutsch connectors Special Instruction, SEHS9615.
Install wedge (16) to the connector (15).
Illustration 18 g00690381
Install two wire harnesses.
Install two nuts (14) and the washers.
Attach two cable straps (13).
Illustration 19 g00690339
Install rocker switch (12).
Install two bolts (11).
Install ground wire and bolt (10).
Illustration 20 g00690337
Install cover (9) to the rocker switch.
Illustration 21 g00690333
Install two screws (8) to the rocker switch assembly.
Illustration 22 g01150237
Install STIC steering control lever (6) to the steering pilot valve (7).
Install two screws (5). Repeat for the other side.
Tighten four screws (5) to 6 1 N m (53 9 lb in).
Illustration 23 g00690331
Install housing (4) and two screws (3). Tighten two screws (3) to a torque of 5 1 N m (44 9 lb in).
Illustration 24 g00690330
Install cover (2) and two screws (1). Tighten two screws (1) to a torque of 5 1 N m (44 9 lb in).End By:
Install the STIC steering pilot valve. Refer to Disassembly and Assembly, "Pilot Valve (STIC Steering) - Install".