ENGINE ARRANGEMENT 1P9587 - Caterpillar

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Illustration 1 g01192179
Disconnect hose assembly (1).
Repeat Step 1 for the other side hose assembly.
Illustration 2 g01187795
Typical example
Attach a suitable lifting device to tilt link (2). The weight of tilt link (2) is approximately 143 kg (315 lb).
Remove bolt (3), the washer and the nut.
Illustration 3 g01187796
Typical example
Remove three plugs (4) .
Illustration 4 g01187797
Typical example
Install Tooling (A). Tighten Tooling (A) evenly to remove collet (5) .
Repeat Step 5 and Step 6 to remove the other side collet.
Illustration 5 g01188112
Typical example
Attach a suitable lifting device to pin (6). The weight of pin (6) is approximately 23 kg (50 lb).
Remove pin (6) .
Illustration 6 g01193222
Typical example
Remove shims (7) .
Secure tilt link (2) to the tilt lever.
Illustration 7 g01192184
Typical example
Attach a suitable lifting device to ejector bucket (8). The weight of the bucket is approximately 5830 kg (12850 lb).
Illustration 8 g01187792
Typical example
Remove bolt (9), the washers and the nut from the lower bucket pin assembly.
Remove three plugs (10) .
Illustration 9 g01187793
Typical example
Install Tooling (A). Tighten Tooling (A) evenly to remove collet (11) .
Repeat Step 14 and Step 15 to remove the other side collet.
Illustration 10 g01192187
Typical example
Use two people to remove pin (13). The weight of pin (13) is approximately 23 kg (50 lb).
Remove shims (12) .
Repeat Step 13 through Step 18 for the bucket pin assembly on the other side.
Remove the ejector bucket.