ENGINE AR-CORE 2000985 - Caterpillar

2000985 ENGINE AR-CORE Caterpillar parts G3520C, G3520E

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2000985
200-0985
2000985

Buy ENGINE AR-CORE 2000985 Caterpillar genuine, new aftermarket tractor parts with delivery
GENERATOR SET,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

$136.91

30 Jan 2020

-: -

SPX NAMEPLATE, PCH (2000985)

Lenox CL 6 2 1/4X3/4 .035 6/8 VPVR (2000985)

$49.60

30 Jan 2020

-: -

Lenox CL 6 2 1/4X3/4 .035 6/8 VPVR (2000985)

$110.22

31 Oct 2018

SPX: SPX

Power Team SPX NAMEPLATE, PCH (2000985)

For full view, you need register

Compatible equipment models: 2000985:

GENERATOR SET G3520C G3520E Caterpillar

Information:

Removal Procedure
Table 1
Required Tooling
Tool Part Number Part Description Quantity
A 138-7574 Link Bracket 3 Start By:
Remove the hammer tool from the hammer. Refer to the Operation and Maintenance Manual, SEBU7662, "Tool (Hammer) - Remove and Install".
Remove the mounting bracket. Refer to the Service Manual, "Mounting Bracket - Remove and Install".
Remove the buffer. Refer to the Service Manual, "Buffer - Remove and Install".
Illustration 1 g00743120
Place the hammer in an upright position on a concrete surface. The surface of the housing must not be damaged or worn. The concrete surface must be level and clean. If the conditions are not stable, you must secure the hammer housing in order to ensure that the hammer will not fall.
Illustration 2 g01244329
Install Tooling (A) , appropriate lifting chains, and a hoist to the accumulator. If the bolts are too long for the threaded hole, use flat washers in order to support the shoulder of the link brackets. The weight of the hammer is approximately 1900 kg (4189 lb).
Illustration 3 g01381737
Lift the hammer enough to place blocking between the housing of the hammer and the valve body of the hammer. The hammer does not need to be removed from the housing.
Remove two pads (1) from the hammer.Installation Procedure
Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.Note: One side of the pads is marked "OUT". When you install the pads, the side that is marked "OUT" should be facing toward the housing of the hammer. The side of the pads that are marked "OUT" should not be facing the hammer.
Illustration 4 g01381737
Place two pads (1) into position in the hammer.
Slowly lower the hammer onto the pads.
Illustration 5 g01244329
Remove Tooling (A) from the hammer.End By:
Install the buffer. Refer to the Service Manual, "Buffer - Remove and Install".
Install the mounting bracket. Refer to the Service Manual, "Mounting Bracket - Remove and Install".
Install the hammer tool from the hammer. Refer to the Operation and Maintenance Manual, "Tool (Hammer) - Remove and Install".