ENGINE AR-PRIMARY 2045372 - Caterpillar

Every 50 Service Hours or Weekly
Actuator Support Bearing (Flexxaire Fan) - Lubricate
Bell Crank (Flexxaire Fan) -Lubricate
Bulldozer - Lubricate
Cab Filter (Recirculation) - Clean/Inspect/Replace
Control Shaft Bushing (Flexxaire Fan) - Lubricate
Fuel Tank Water and Sediment - Drain
Lift Cylinder Yoke Bearings - Lubricate
Ripper Linkage and Cylinder Bearings - Lubricate
Track Pins - Inspect
Initial 250 Service Hours (or at first oil change)
Engine Valve Lash - Check/Adjust
Engine Valve Rotators - Inspect
Every 250 Service Hours
Engine Oil Sample - Obtain
Every 250 Service Hours or Monthly
Air Conditioner Belt - Inspect/Adjust/Replace
Alternator and Fan Belts - Inspect/Adjust/Replace
Cooling System (DEAC) Additive - Add
Engine Oil and Filter - Change
Fan Drive Pulley and Idler - Lubricate
Final Drive Oil Level - Check
Track - Check/Adjust
Every 500 Service Hours
Coolant Sample (Level 1) - Obtain
Final Drive Seal Guard - Inspect/Clean
Every 500 Service Hours or 3 Months
Engine Crankcase Breather - Clean
Final Drive Oil Sample - Obtain
Fuel System Primary Filter - Clean/Replace
Fuel System Secondary Filter - Replace
Fuel Tank Cap Filter and Strainer - Replace/Clean
Hydraulic System Oil Filters - Replace
Hydraulic System Oil Sample - Obtain
Recoil Spring Compartment Oil Level - Check
Transmission Breather - Clean
Transmission System Oil Sample - Obtain
Transmission and Torque Converter Oil Filters - Replace
Every 1000 Service Hours or 6 Months
Battery - Inspect
Blades (Flexxaire Fan) - Inspect
Hub Oil Level (Flexxaire Fan) - Check
Hydraulic System Oil Filter (Pilot) - Replace
Rollover Protective Structure (ROPS) - Inspect
Transmission System Oil and Screens - Change/Clean
Every 2000 Service Hours
Final Drive Seal Guard Packing - Replace
Every 2000 Service Hours or 1 Year
Air Conditioner Condenser - Clean
Engine Mounts and Equalizer Bar - Inspect
Engine Valve Lash - Check/Adjust
Engine Valve Rotators - Inspect
Final Drive Oil - Change
Hydraulic System Oil - Change
Track Roller Frame - Inspect
Track Roller Frame Guides - Inspect
Every Year
Coolant Sample (Level 2) - Obtain
Engine Air Filter Primary Element - Replace
Refrigerant Dryer - Replace
Every 3000 Service Hours or 2 Years
Cooling System (DEAC) Coolant - Change
Every 3 Years After Date of Installation or Every 5 Years After Date of Manufacture
Seat Belt - Replace
Every 6000 Service Hours
Bearing Block Seal - Replace
Every 6000 Service Hours or 3 Years
Cooling System Extended Life Coolant Extender - Add
Cooling System Water Temperature Regulator - Replace
External Engine Components - Inspect
Every 6000 Service Hours or 4 Years
Hub Oil (Flexxaire Fan) - Change
Every 12 000 Service Hours or 6 Years
Cooling System (ELC) Coolant - Change