ENGINE AR-GENSET 20R3655 - Caterpillar

1. Stop the machine on level ground. Push the governor control forward slightly to reduce the engine speed.
Stopping the engine immediately after it has been working under load, can result in overheating and accelerated wear of the engine components. Follow the stopping procedure, outlined below, to allow the engine to cool, and to prevent excessive temperatures in the turbocharger centerhousing which will cause oil coking problems.
2. Move the power shift transmission control lever to NEUTRAL.Move the direct drive directional control lever to NEUTRAL.3. Engage the parking brake.4. Lower all raised equipment to the ground. Apply a slight down pressure.5. Before stopping the engine, operate at LOW IDLE for five minutes. This allows hot areas in the engine to cool gradually, extending engine life.6. Push the governor control lever past detent (all the way forward), to stop the engine.7. Turn the start switch key to OFF. Remove the key.8. Install the vandalism guards (if equipped) when leaving the machine for an extended period.Electrical Disconnect Switch
The switch is located on the left side of the machine behind the access cover.Turn the key off and remove the key, if parking for an extended period of time, to prevent battery drain by vandalism, or when servicing the machine.This will also prevent the engine from being started or lights being turned on by unauthorized people.