ENGINE AR 2178411 - Caterpillar

Personal injury can result from hot oil spray and raised attachments.Make sure all attachments have been lowered, oil is cool and the pressure has been released from the hydraulic system before removing any components or lines.Do not allow hot oil or components to contact skin.
Do not check for leaks with your hands. Pin hole (very small) leaks can result in a high velocity oil stream that will be invisible close to the hose. This oil can penetrate the skin and cause personal injury. Use cardboard or paper to locate pin hole leaks.
Table 1
REQUIRED TOOLS    
Part Number    Part Description    Quantity    
6V-7788     Oil Flow Meter     1    
8C-6874     Connector     2    
6V-8943     Reducer Assembly     2    
7X-3165     Swivel Adapter     2    
6V-9746     O-Ring Seal     2    
7J-9108     O-Ring Seal     2    
2M-9780     O-Ring Seal     2    
153-2994     Coupling     1    
153-2995     Coupling     1    
9U-7400     Multitach Tool Group     1    Flow Meter Assembly
Illustration 1 g00614286
Apply 5P-3413 Pipe Sealant to the pipe threads of 8C-6874 Connector (7). Install connector (7) at each end of 6V-7788 Oil Flow Meter (8) .
Install 6V-9746 O-Ring Seal (6) onto the face of each connector.
Install 6V-8943 Reducer Assembly (5) onto each connector.
Install 7J-9108 O-Ring Seal (4) onto the face of each reducer assembly.
Install 7X-3165 Swivel Adapter (3) onto each reducer assembly.
Install 2M-9780 O-Ring Seal (2) onto each swivel adapter.
Install 153-2994 Coupling (1) onto the input side of the flow meter assembly.
Install 153-2995 Coupling (9) onto the output side of the flow meter assembly.Output Test for the Gerotor Motor
Install the landscape tiller onto the skid steer loader. Refer to Operation and Maintenance Manual, SEBU7753, "Work Tool Installation".
Illustration 2 g00638895
Connect flow meter assembly (4) to coupling (3) .
Connect hydraulic hose (5) to the flow meter assembly.Note: Do not route the hydraulic hoses through the hose guide on the skid steer loader.
Connect hydraulic hose (2) to upper coupling (1) .
Illustration 3 g00638897
Apply a 13 mm (0.5 inch) strip of reflective tape (8) onto each of the tiller tines (9) that are close to motor housing (6) .
Mount photo tach (7) of the 9U-7400 Multitach Tool Group to motor housing (6) .
Enter the host machine.
Fasten the seat belt and lower the armrest.
Start the host machine.
Raise the landscape tiller slightly off the ground.
Place the auxiliary hydraulic control to the AUX 1 position and activate the continuous flow control.
Increase engine speed until the flow meter reads 38 L/min (10 US gpm).
Check the output rpm on the multitach. The reading should be approximately 66 10 rpm.If the output rpm is less than 56 rpm, there may be excessive leakage within the gerotor motor. Replace the gerotor motor.
Deactivate the auxiliary hydraulic control.
Lower the landscape tiller to the ground.
Decrease the engine speed to LOW IDLE and stop the engine.