ENGINE AR 2186650 - Caterpillar

CAT P/N Required for this operation:
Table 8
S.NO     CAT P/N     Type     Qty    
1     3E-8866     Wire As     1    
2     136-4877     Wire Splice     1    Mfg Tools Required:
Cutter
Crimp toolSplice Sectional View:
Refer to the following Illustration for section view of Splice.
Illustration 16 g02959156
(1) Insulation Sleeve (2) Crimp SpliceSpecial Instructions for 3E-8866 Installation in Place of 9X-9381 Wire As
These special instructions are used to install 3E-8866 Wire As in Place of 9X-9381 Wire As by removing excess wire material in 3E-8866 Wire As .Instructions to modify 3E-8866 Wire As :
The illustrations 17 and 18 shows the 3E-8866 Wire As and the 9X-9381 Wire As .
Illustration 17 g02959377
(1) 5P-4571 Blade Terminal (2) 8T-1487 Electrical Wire
Illustration 18 g02970076
(1) 5P-4571 Blade Terminal (2) 8T-1487 Electrical Wire
Illustration 19 g02970057
Cut the 8T-1487 Electrical Wire at position 1 & 2 in 3E-8866 Wire As as per the positions and dimensions shown in Illustration 19.
Remove excess wire material and Strip the wires 6 mm (0.2 inch) to 10 mm (0.4 inch), insert into opposite ends of the crimp barrel of 136-4877 Wire Splice .
Crimp the Splice to join the wires with Crimp tool.
The Insulation Sleeve of the splice must be heated along its entire length until the crimp marks are gone and the ends of the sleeve recover onto the wires.
Assemble the Wire Assembly to NHL Control Gp - Mountings with the help of terminal locations shown in Table 9.
Table 9
S.No     CAT P/N     TERMINAL LOC-1     GAUGE     LENGTH     TERMINAL LOC-2    
1     9X-9381     TB392-L10     16     75     TB392-R10    CAT P/N Required for this operation:
Table 10
S.NO     CAT P/N     Type     Qty    
1     3E-8866     Wire As     1    
2     136-4877     Wire Splice     1    Mfg Tools Required:
Cutter
Crimp toolSplice Sectional View:
Refer to the following Illustration for section view of Splice.
Illustration 20 g02959156
(1) Insulation Sleeve (2) Crimp Splice