ENGINE AR-COMPLETE 2260003 - Caterpillar

Illustration 1 g03694590
The battery disconnect switch is located on the left side of the machine behind the small access door in the fender enclosure.
On the stalled machine, turn the battery disconnect switch to the ON position. Turn all of the accessories to the OFF position.
Move the machine that is used for the electrical source close to the stalled machine. The cables must reach. DO NOT ALLOW THE MACHINES TO CONTACT EACH OTHER.
Stop the engine on the machine that is used for the electrical source. When you use an auxiliary power source, turn the charging system to the OFF position.
Illustration 2 g03702227
Some components are removed for clarity.
The auxiliary start receptacle is inside the left engine compartment.
On the stalled machine, connect the 9S-3664 Plug Assembly to the auxiliary start receptacle.
Connect the other end of this cable to the electrical source. You must connect the cable to the auxiliary start receptacle.
Start the engine on the machine that is used for the electrical source. Also, you can energize the charging system on the auxiliary power source.
Allow the electrical source to charge the batteries for 2 minutes.
Attempt to start the stalled engine. Refer to Operation and Maintenance Manual, "Engine Starting". See the beginning of this topic.
Immediately after the stalled engine starts, disconnect the jump-start cable from the electrical source.
Disconnect the other end of this cable from the stalled machine.
Conclude with a failure analysis on the starting charging system. Check the stalled machine, as required. Check the machine when the engine is running and the charging system is in operation.