ENGINE AR-COMPLETE 2281132 - Caterpillar

Start By:a. remove steering clutches 1. Remove brake band (2) and outer drum (1) from the steering clutch. 2. Install tooling (B) to the end of the clutch shaft and install it in a vise.3. Remove lock (3). Use tooling (A) and loosen nut (4) until it is even with the top of the shaft.
Do not remove nut (4). This will keep the drum on the shaft when it is loosened from the taper on the shaft.
4. Remove the steering clutch from the vise. The weight is approximately 45 kg (100 lb).5. Use tooling (D) as shown to push the shaft from the inner drum. Remove tooling (D) and nut (4). Remove the shaft from the steering clutch. 6. Install tooling (H) on the other side of the steering clutch and install it in a vise.7. Remove two setscrews (5). Use tool (E) and remove spanner nut (6) from the plate assembly. 8. Bend locks (7) down and remove bolts (8) that hold the yoke in place.9. Remove yoke (9) from the plate assembly. 10. Use a pry bar on each side of the bearing cage and remove bearing cage (10) from the plate assembly. 11. Remove retaining ring (11) from bearing cage (10). 12. Remove bearing (12) from bearing cage (10). 13. Put two pieces of wood (13) on tool (F), as shown, as a support for the steering clutches. Install drum (1). Make an alignment of the centers of the clutches and drum (1).
Use only enough force to put the steering clutch springs under compression to remove the locks from the studs. Be extra careful that the 5P3036 Installer Ring moves freely on the studs.
14. Install tooling (C), as shown, and put the steering clutch spring under compression. 15. Remove locks (14) from the studs.16. Slowly release the pressure on the steering clutch springs. Remove tooling (C). Only oil-cooled steering clutches have spacers located under springs (16).17. Remove retainers (15), springs (16) and the spacers from the studs. 18. Install tooling (G) as shown. Fasten a hoist and remove inner drum (17). 19. Remove steering clutch discs (18).20. Remove studs (19) from the plate assembly.Assemble Steering Clutches
1. Install studs (19) in the plate assembly.2. Put the plate assembly and outer drum (1) in position on tool (I). Install steering clutch disc (18). Start and stop with a disc that has teeth on the outside diameter. Make a visual alignment of the inside diameter of the discs. 3. Install tooling (J) to inner drum (17) and fasten a hoist. Install inner drum (17). 4. Install spacers, springs (16) and retainer (15) on studs.
Use only enough force to put the steering clutch springs under compression to remove the locks on the studs. Be extra careful that the 5P3036 Installer Ring moves freely on the studs.
5. Install tooling (K) and put springs (16) under compression. Install locks (14) on the studs.6. Remove tooling (K). Remove the steering clutch from tool (I). Remove outer drum (1). 7. Install bearing