ENGINE AR-CORE 2292642 - Caterpillar

Illustration 2 g03506603
Typical example
(7) New Project icon
(8) New Project
(9) Connection wizard icon
Select New Project icon (7). New Project (8) will appear. Select Connection wizard icon (9).
Illustration 3 g03509616
Typical example
(10) Show all connected devices
(11) Next button
Select Show all connected devices (10), then click Next button (11).
Illustration 4 g03509617
Typical example
(12) Internet Protocol (IP)
(13) Next button
Ensure Internet Protocol (IP) (12) is selected. Select Next button (13).
Illustration 5 g03509618
Typical example
(14) Check box
(15) 10.10.30.1
(16) Manually button
A new installed LADAR will appear in the list as "10.10.30.1" (15). "10.10.30.1" (15) is the default LADAR IP address. Select the "10.10.30.1:2111" device and select check box (14). Select Manually button (16) to change the device IP settings. Expected Result:The connected LADAR is located by the Auto IP Scan.Results:
YES - The connected LADAR is located by the Auto IP Scan. Proceed to Test Step 2.
NO - The connected LADAR is not located by the Auto IP Scan.Repair: The LADAR is not communicating. Replace the LADAR. Refer to:Troubleshooting, Testing and Adjusting, "Sensor (LADAR) configure (Replace, Adjust, and Configure)".STOPTest Step 2. CHECK THE LADAR IP ADDRESS CONFIGURATION
Illustration 6 g03509636
Typical example
(17) Default IP address:
(18) OK button
Illustration 7 g03509637
Typical example
(19) IP address:
(20) Subnetmask address
Click Manually button (16) in the Change device IP settings section. Refer to Illustration 5.
Examine the LADARs IP address (19) and Subnetmask address (20). Expected Result:The IP address matches the address recorded during device configuration, and is within the range 10.10.30.2 - 10.10.30.254. Subnetmask address (20) is 255.255.0.0.Results:
YES - The IP address matches address recorded during device configuration, and is within the range 10.10.30.2 - 10.10.30.254. Subnetmask address is 255.255.0.0. Proceed to Test Step 3.
NO - The IP address matches address recorded during device configuration, and is not within the range 10.10.30.2 - 10.10.30.254. Subnetmask address is not 255.255.0.0.Repair: The LADAR configuration is incorrect. Refer to Troubleshooting, Testing, and Adjusting, "Sensor (LADAR) - Configure (IP Address Configuration)" in this manual.STOPTest Step 3. CHECK ETHERNET CONNECTIVITY BETWEEN THE LADAR HARNESS CONNECTION AND THE AECM
Connect the laptop to LADAR Ethernet harness connection using the 453-4119 Cable As.
Start the "Software Manager" software. Note: "Software Manager" is available for download from http://.dealer.cat.com.
Illustration 8 g03838201
(21) "Scan Now" button
In the "Software Manager", click "Scan Now" button (21). Expected Result:The AECM fitted to the machine is found by the "Software Manager".Results:
YES - The AECM fitted to the machine is found by the "Software Manager"STOP
NO - The AECM fitted to the machine is not found by the