AVSPARE.COM
parts catalog

ENGINE AR-COMPLETE 2444606 - Caterpillar



2444606 ENGINE AR-COMPLETE Caterpillar parts C-16 ENGINE
Rating:
75
Alternative (cross code) number:
CA2444606
244-4606
2444606
Caterpillar 2444606 ENGINE AR-COMPLETE

Buy ENGINE AR-COMPLETE 2444606 Caterpillar genuine, new aftermarket tractor parts with delivery
TRUCK ENGINE,

Compatible equipment models: 2444606:

TRUCK ENGINE  C-16   Caterpillar
  For full view, you need register

Information:

Caterpillar: Confidential Yellow
PSP FOR INCREASING THE WELD WEAR BUFFER AND INCREASING THE STRENGTH OF THE END PLATE ASSEMBLIES ON U AND SU BULLDOZERS FOR D9N TRACTORS - PS0385 - MAILED US AND CANADA, CACO, COFA, CFEL, COSA
  The information supplied in this service letter may not be valid after the termination date of this program.   Do not perform the work outlined in this Service Letter after the termination date without first contacting your Caterpillar product analyst.
U-92 A-68 AU-61 E-44 O-61 6050 PS0385 This Program can only be administered after a failure occurs on customer units. However, it is recommended that dealer inventory units be reworked on a before failure basis. The decision whether to apply the Program is made by the dealer. When reporting the repair, use "PS0385" as Part Number, "7755" as Group Number, and "96" as Description Code. Termination Date
April 30, 1990
Problem
A wear buffer is required to protect the bevel weld that connects the bulldozer end plate to the moldboard. This buffer weld may not be as large as desired on units shipped to the dealer prior to February 13, 1989. Additional strength may also be required on the end plate assemblies incertain high impact conditions. The end plate assemblies can be strengthened by welding the bottom shoe directly to the router bit.
Affected Product
Model Identification Number D9N 1JD1-Up If shipped to the dealer prior to February 13, 1989.
Parts Needed
Not Applicable
Action Required
Clean the paint from the moldboard to end plate welds at both ends of the blade. Increase the size of the buffer weld until it is 31 mm (1.2") wide or wider and 10 mm (.4") deep at the throat. Use E7018 rod, E11018 rod, or low hydrogen wire to make the welds. Paint the areas where the size of

Caterpillar SIS machinery equipment:

Caterpillar SIS


Parts engine Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.