ENGINE AR-COMPLETE 2444790 - Caterpillar

Illustration 1 g03339052
Table 1
Specification for 290-9333 Hoe Stick Gp
Item Qty Part Specification Description
- All bores must be free of paint. Coat all bores for pins, the bucket, and cylinder pin bores with 5P-0960 Grease Cartridge.
- Assemble the Bearings with the identification numbers of the sleeve bearings facing outward.
1 - - Stick cylinder must be assembled so that grease zerk is directed as shown in illustration 1
2 1 107-9852 Pin As Diameter is 69.850 0.025 mm (2.7500 0.0010 inch).
3 1 4I-4811 Pin As Diameter is 69.850 0.025 mm (2.7500 0.0010 inch)
4 Use any one of the following bushing given below:
2 244-4277 Bushing Bore before assembly is 90.16 0.02 mm (3.550 0.001 inch).
Installation Depth is 9.5 0.8 mm (0.37 0.03 inch)
2 228-5615 Bushing Bore before assembly is 90.25 0.04 mm (3.553 0.002 inch).
Installation Depth is 9.5 0.8 mm (0.37 0.03 inch)
5 2 229-1096 Bushing Bore before assembly is 70.17 0.04 mm (2.763 0.002 inch).
Installation Depth is 9.5 0.8 mm (0.37 0.03 inch)
6 4 235-7679 Lip Type Seal Lubricate the sealing lip lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces outside, as shown. Install lip type seals so that the lip type seals do not extend beyond the face of the boss.
7 2 228-5614 Bushing Bore before assembly is 70.17 0.04 mm (2.763 0.002 inch).
Installation Depth is 9.5 0.8 mm (0.37 0.03 inch)
8 4 166-1495 Lip Type Seal Lubricate the sealing lip lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces outside, as shown. Install lip type seals so that the lip type seals do not extend beyond the face of the boss.