ENGINE AR-COMPLETE 2457001 - Caterpillar

Connect the control harness (11) to the satellite receiver (8) .Setting the Language
The operator can use the user interface of the on-board software in either English, French, Spanish, Portuguese, or Swedish. The default is English. Enable one of the non-default languages using a line of code containing a language identifier from Table 2.Note: The on-board software receives tasks from other applications such as Task List Manager. These tasks can be sent in any language that is supported by the keyboard and operating system being used. The on-board software receives these tasks in any language that the operating system supports.
Table 2
Language    Language Identifier    
French     fra    
Spanish     esp    
Swedish     sve    
Portuguese     prt    To set the language of the user interface, add the following line to the startcaes.cmd file before running the file:
SET lang=<language identifier>
Illustration 12 g02340196
The line must be added before the c:\caes\exe line. For example, to set the language of the user interface to Spanish, add the following line as shown in Illustration 12:
SET lang=espUsing the Machine Configuration Utility
The Machine Configuration Utility (MCU) is a tool that configures advanced machine settings. The software replaces the previous method of editing the machine configuration file (mach_cfg.txt) file by hand. ReferenceFor information on using the MCU, select Start > All Programs > Cat MineStar System and Tools > Machine Configuration Utility.ReferenceFor information on adding the machine in Cat MineStar System, refer to Systems Operation, RENR9562, " Terrain User Guide".Performing the Dimension Measurements and Measure Up
Perform the calibration for the machine as listed in the specific section for your machine in ""Performing the Calibrations"".
Open the MCU.
Select the machine name.
Select Machine > Machine Dimensions. Enter the dimensions.
In the Menu Bar, select File > Send to Cat MineStar System.
Ask the Terrain Site Champion to send out a site-specific application file for the satellite receiver.
Restart the on-board system and verify the accuracy of the satellite receiver as follows:
Move the machine origin to a known point.
Compare the Northing, Easting, and Elevation.Performing the Calibrations
Enter correct details. Any errors transfer directly into the finished surface.
Illustration 13 g03231916
Phase center (12) on the satellite receiverWhen a measurement refers to the phase center, the phase center (12) is located 12.8 cm (5.0 inch) (double-sided arrow) from the bottom of the satellite receiver.ReferenceRefer to "Machine Dimensions" in the MCU Help for the following steps:Calibrating Wheel Loaders
Illustration 14 g03099718
Wheel loader machine dimensions
Measure the machine GPS receiver offsets.ReferenceRefer to Illustration 14, as a reference guide and template to record the machine dimensions. Note: The "X" measurement that is taken to the right of