2498413 ENGINE AR-COMPLETE Caterpillar parts
C11
Rating:
Alternative (cross code) number:
CA2498413
249-8413
2498413
CA2498413
249-8413
2498413
TRUCK ENGINE,
Compatible equipment models: 2498413:
For full view, you need register
Information:
Removal Procedure
Start By:
Remove the hydraulic hammer from the housing. Refer to Disassembly and Assembly, "Hydraulic Hammer - Remove".
Illustration 1 g02645998
Inspect the wear plates for excessive wear. Refer to Service Manual, "Wear Plates" for the specifications of the plates. If the wear plates are worn excessively or the plates are damaged, the wear plates must be replaced.
By reaching through the bottom of the hammer housing, use a suitable prybar to remove plates (1) to be replaced.
Alternatively, wear plates (1) can be rotated to extend component life.
Remove bottom damper (2). Installation Procedure
Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement, if necessary.
Illustration 2 g02645998
Install bottom damper (2). If installing new wear plates (1), place the wear plates into position on the pins in the lower end of hammer housing. Ensure that the wear plates do not cover any openings.
Press or tap the new plates onto the pins in the housing.
Alternatively, wear plates (1) can be rotated to extend component life. End By:
Install the hydraulic hammer into the hammer housing. Refer to the Disassembly and Assembly, "Hydraulic Hammer - Install".
Start By:
Remove the hydraulic hammer from the housing. Refer to Disassembly and Assembly, "Hydraulic Hammer - Remove".
Illustration 1 g02645998
Inspect the wear plates for excessive wear. Refer to Service Manual, "Wear Plates" for the specifications of the plates. If the wear plates are worn excessively or the plates are damaged, the wear plates must be replaced.
By reaching through the bottom of the hammer housing, use a suitable prybar to remove plates (1) to be replaced.
Alternatively, wear plates (1) can be rotated to extend component life.
Remove bottom damper (2). Installation Procedure
Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement, if necessary.
Illustration 2 g02645998
Install bottom damper (2). If installing new wear plates (1), place the wear plates into position on the pins in the lower end of hammer housing. Ensure that the wear plates do not cover any openings.
Press or tap the new plates onto the pins in the housing.
Alternatively, wear plates (1) can be rotated to extend component life. End By:
Install the hydraulic hammer into the hammer housing. Refer to the Disassembly and Assembly, "Hydraulic Hammer - Install".