2549435 ENGINE AR-COMPLETE Caterpillar parts
C15
Rating:
Alternative (cross code) number:
CA2549435
254-9435
2549435
CA2549435
254-9435
2549435
TRUCK ENGINE,
Compatible equipment models: 2549435:
For full view, you need register
Information:
Removal Procedure
Table 1
Required Tools
Item Part Number Part Description Qty
A 200-2959 Shear Lock Gp
VHP-30 1
200-2960 Shear Lock Gp
VHP-40 1
200-2885 Shear Lock Gp
VHP-50 1
Open the jaw of the work tool.
Illustration 1 g02249313
In order to hold the movable jaw in the open position, install Tooling (A) onto cover (1). Tool (A) must be installed behind guide block (2) for cover (1) .
Illustration 2 g02249353
Remove screws (3), the nuts, shims (5), and cutters (5) from the work tool.Installation Procedure
Illustration 3 g02249353
Thoroughly clean all contact surfaces before installing the new cutters. Remove any rust, paint, nicks, and burrs from the surfaces.
Install shims (5), cutters (4), screws (3), and the nuts to the work tool. Tighten screws (3) to a torque of 460 60 N m (339 44 lb ft)Note: Use new screws when the cutter will be replaced.Note: Divide the shims equally in the moveable jaw and the fixed jaw.
Illustration 4 g02249313
Remove Tooling (A) from behind guide block (2) and cover (1) .
Slowly close the removable jaw on the work tool.
Measure the clearance between the cutter (4) of the movable jaw and the cutter of the fixed jaw. The clearance between the two cutters must be less than 0.5 mm (0.02 inch). Use the shims (5) to adjust the amount of clearance.
Table 1
Required Tools
Item Part Number Part Description Qty
A 200-2959 Shear Lock Gp
VHP-30 1
200-2960 Shear Lock Gp
VHP-40 1
200-2885 Shear Lock Gp
VHP-50 1
Open the jaw of the work tool.
Illustration 1 g02249313
In order to hold the movable jaw in the open position, install Tooling (A) onto cover (1). Tool (A) must be installed behind guide block (2) for cover (1) .
Illustration 2 g02249353
Remove screws (3), the nuts, shims (5), and cutters (5) from the work tool.Installation Procedure
Illustration 3 g02249353
Thoroughly clean all contact surfaces before installing the new cutters. Remove any rust, paint, nicks, and burrs from the surfaces.
Install shims (5), cutters (4), screws (3), and the nuts to the work tool. Tighten screws (3) to a torque of 460 60 N m (339 44 lb ft)Note: Use new screws when the cutter will be replaced.Note: Divide the shims equally in the moveable jaw and the fixed jaw.
Illustration 4 g02249313
Remove Tooling (A) from behind guide block (2) and cover (1) .
Slowly close the removable jaw on the work tool.
Measure the clearance between the cutter (4) of the movable jaw and the cutter of the fixed jaw. The clearance between the two cutters must be less than 0.5 mm (0.02 inch). Use the shims (5) to adjust the amount of clearance.