2615488 ENGINE AR-COMPLETE Caterpillar parts
C11
Rating:
Alternative (cross code) number:
CA2615488
261-5488
2615488
CA2615488
261-5488
2615488
TRUCK ENGINE,
Compatible equipment models: 2615488:
Information:
Disassembly Procedure
Start By:
Remove the rotator motor and manifold.
Illustration 1 g00688971
Place the rotator motor in a soft jawed vise so that the output shaft is pointed downward.
Make an alignment mark from the cover to the housing.
Illustration 2 g00688988
Remove bolts (1).
Illustration 3 g00689046
Remove cover (2) and O-ring seal (3).
Illustration 4 g00689048
Remove plate (4) and O-ring seal (5).
Illustration 5 g00689062
Remove manifold (6). Remove two O-ring seals (7).
Illustration 6 g00689069
Remove rotor set (8) and plate (9) together. Note: Removing the rotor set and the plate together will retain the rotor set in the assembled form. This will maintain the same contact surfaces between the rotor vane and the stator.
Illustration 7 g00689083
Remove link (10).
Illustration 8 g01263241
Remove bearing (12).
Remove O-ring seal (11).
Illustration 9 g01263057
Remove output shaft (13). Remove the square key from the output shaft and inspect the square key.
Start By:
Remove the rotator motor and manifold.
Illustration 1 g00688971
Place the rotator motor in a soft jawed vise so that the output shaft is pointed downward.
Make an alignment mark from the cover to the housing.
Illustration 2 g00688988
Remove bolts (1).
Illustration 3 g00689046
Remove cover (2) and O-ring seal (3).
Illustration 4 g00689048
Remove plate (4) and O-ring seal (5).
Illustration 5 g00689062
Remove manifold (6). Remove two O-ring seals (7).
Illustration 6 g00689069
Remove rotor set (8) and plate (9) together. Note: Removing the rotor set and the plate together will retain the rotor set in the assembled form. This will maintain the same contact surfaces between the rotor vane and the stator.
Illustration 7 g00689083
Remove link (10).
Illustration 8 g01263241
Remove bearing (12).
Remove O-ring seal (11).
Illustration 9 g01263057
Remove output shaft (13). Remove the square key from the output shaft and inspect the square key.