ENGINE AR-COMPLETE 2673305 - Caterpillar

2673305 ENGINE AR-COMPLETE Caterpillar parts C4.4

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2673305
267-3305
2673305

Buy ENGINE AR-COMPLETE 2673305 Caterpillar genuine, new aftermarket tractor parts with delivery
GENERATOR SET,

Compatible equipment models: 2673305:

GENERATOR SET C4.4 Caterpillar

For full view, you need register

Information:

TYPE="LEVEL" DEPTH="1" @@@-->Specifications
Table 1
Parameter Value
Fuel Supply Pressure
83 to 586 kPa (12 to 85 psig) (1)
Fuel Pressure to Control Valve
10.3 to 24.1 kPa (1.5 to 3.5 psig)
( 1 ) The recommended supply pressure range is 30-35 psig.Introduction
Use this procedure to check the regulated fuel pressure. Make sure that the fuel supply pressure is correct.Required Tools
Table 2
Required Tools
Qty Part Number
1 1U-5470 Engine Pressure Gp
1 8T-5160 Gas Regulator Setting Tool
Illustration 1 g01192577
1U-5470 Engine Pressure Group (1) Pressure indicators (2) Zero adjustment screw (3) Pressure indicator (4) Pressure tap (5) Pressure indicatorThis tool group has an indicator that is used to read the pressure in the fuel lines. The Special Instruction, SEHS8907 is with the tool group.Test Preparation - Fuel Pressure to Control Valve
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.
Illustration 2 g03671390
(6) Gas line (7) Gas pressure sensor (8) Fuel control valve (9) Gas Shutoff Valve (GSOV)
Turn off the main gas valve.
De-energize GSOV (9) .
Slowly remove gas pressure sensor (7) from gas line (6) .
Install a fitting into gas line (6). Connect the 1U-5470 Engine Pressure Gp to the fitting. Refer to Illustration 1.Test Procedure - Fuel Pressure to Control Valve
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.
Open the main gas valve.
Energize the GSOV.
Check the engine gas pressure to the fuel control valve. If, the pressure is not 10.3 to 24.1 kPa (1.5 to 3.5 psig) refer to Adjustment Procedure - Fuel Pressure to Fuel Control Valve.Adjustment Procedure - Fuel Pressure to Fuel Control Valve
Illustration 3 g03333365
(10) Bolt (11) Cover
Remove cover (11), and install the correct tools, from the 8T-5160 Gas Regulator Setting Tool, for pressure setting adjustment.
Adjust bolt (10) to achieve desired fuel pressure to the fuel control valve.
After desired pressure is reached, install cap (11) .