ENGINE AR-COMPLETE 2724676 - Caterpillar

33. Remove cotter pin (43) and pin (44) from carriage assembly (12) and tooth group (45). Remove tooth group (45) from carriage assembly (12). 34. Use a hammer and a punch in order to remove pin (46) from tooth group (45).35. Remove tip (47) from tooth group (45). The following steps are for the installation of the ripper.36. During the installation of the ripper, check the condition of all the O-ring seals used on the hydraulic hose assemblies that were disconnected. If any of these seals are damaged, use new parts for replacement. 37. Install tip (47) to tooth group (46). Install the rest of the tips to the tooth groups.38. Install pin (46) in order to hold the tip to the tooth group. Repeat this step on the remaining tooth groups. 39. Install tooth group (45) to carriage assembly (12). Install the rest of the tooth groups in the carriage assembly.40. Install pin (44) and cotter pin (43) in order to secure tooth group (45) to carriage assembly (12). Repeat this step on the rest of the tooth groups. 41. Attach lifting slings and a hoist to mounting bracket (16). Position mounting bracket (16) to the machine frame.42. Install bolts (42) and washers that hold mounting bracket (16) to the machine frame. Tighten bolts (42) to a torque of 1050 150 N m (770 110 lb ft).43. Connect hose assemblies (41) to their original locations on the mounting bracket (16). 44. Install bolts (40) and washers to bottom of mounting bracket (16). Tighten bolts (40) to a torque of 1050 150 N m (770 110 lb ft). 45. Install wiring harness (38) and grommet to plate (39).46. Position plate (39) to the radiator guard. Install bolts (37) and washers that hold plate (39) to the radiator guard. 47. Position grill (36) to the radiator guard. Before installing the grill (36), connect wiring harness (38).48. Install six bolts (35) to grill (36) and the radiator guard. 49. Attach a lifting sling and a hoist to stabilizer bar (32). Position cam assembly (34) to its original orientation, as marked.50. Position pin (21) to the inside of mounting group (35). Position stabilizer bar (32) and spacer (37) to mounting group (16). Align the pin retention holes.51. Install pin (21) through spacer (37), stabilizer bar (32), cam assembly (34) and mounting group (35). Repeat this step for the other spacer, cam and stabilizer bar. 52. Use a