ENGINE AR-COMPLETE 2840179 - Caterpillar

Table 1
Swath Option 0 =0 6 2
Specifies that the cells swathed by the bucket tip are set to mining in progress. Swath point 0 on the wheel loader is the maximum reach. Maximum reach is the furthest extent to which the bucket can remove material. Category 6 specifies that the material status as-built ore surface is to be updated. The swath point function 2 requires that the status be set to "Mining in progress".
Swath Option 1 =1 5 1
Specifies that the cells swathed by the front wheels of the Wheel Loader are set to mined out. Swath point 1 on the wheel loader is the wheel radius front. Category 5 specifies that material status as-built elevation surface is to be updated. The swath point function 1 requires that the status is set to "Mined out".
Swath Option 2 =1 6 1
Specifies that the cells swathed by the front wheels of the wheel loader are set to mined out. Swath point 1 on the wheel loader is the wheel radius front. Category 6 specifies that the material status as-built ore surface is to be updated. The swath point function 1 requires that the status is set to "Mined out". Note: The "Mined out" status is not overwritten by the "Mining in progress" status. This configuration assumes that any area traversed by the wheel loader can be considered to be mined out."Data File Param" - Set up to both create and to identify the material status as-built surface file. The on-board software presents material status information in the ore plan. The material status is drawn over the top of the material design information. The default format for the material status information is:"Not mined" - No change"Mining in progress" - Cross hatched, charcoal lines"Mined out" - Solid fill with charcoal colorThe following setting sets the color that is used to represent material that has been mined out:"Ore Mined Color" - Sets the color number for mined out material in the on-board software
Illustration 1 g03396154
Ore plan showing both material design and material status
(1) Area where material has not been removed
(2) The maximum reach of the wheel loader.
(3) Area where material is being removed
(4) Area where all material has been removed