ENGINE AR-CORE 2956010 - Caterpillar

1. Turn the crankshaft until the "C" mark on the crankshaft gear (3) is in alignment with the "C" mark on camshaft gear (1).2. Put a mark on the teeth of the idler gear and camshaft gear at location (A). The timing of the fuel injection pump will be correct if the gear teeth have identification marks.3. Remove camshaft bolts (2), the lock and thrust washer.4. Pull the camshaft out of the cylinder block.
Do not cause damage to the lobes or bearing journals when the camshaft is removed.
5. Remove the bolts that hold the camshaft gear to the camshaft. Remove the gear.Install Camshaft
1. Put the camshaft drive gear in position on the end of the shaft. The drive gear will fit on the camshaft one way only.2. Install the bolts that hold the drive gear in position.3. Put clean SAE 30 oil on the lobes and bearing journals of the camshaft. 4. Install camshaft (1) in the cylinder block. 5. Install the thrust washer, locks and bolts (2) that hold the camshaft in the cylinder block.end by:a) install timing gear coverb) install valve lifters