3090318 ENGINE AR-PRIMARY Caterpillar parts
C4.4
Rating:
Alternative (cross code) number:
CA3090318
309-0318
3090318
CA3090318
309-0318
3090318
INDUSTRIAL ENGINE,
Related part:
3090318
BLOCK GP-LONG
20R2687
R
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
$62.49
14 Jul 2021
7.0[3.15] Pounds
US: ALL ACCESSORY C
9pc Safari Tan Leopard Print Car Floor Mats, High Back Seat Covers, Steering Wheel Cover & Shoulder Pad Set
la auto Easy Installation || 2 Seat Covers || 4 floor mats || 1 Steering Wheel Cover || 2 Shoulder Belt Pads
la auto Easy Installation || 2 Seat Covers || 4 floor mats || 1 Steering Wheel Cover || 2 Shoulder Belt Pads
For full view, you need register
3090318
Images:
Compatible equipment models: 3090318:
Information:
Introduction
This instruction gives the procedure for replacing the Chevron packing in an hydraulic cylinder with a U-cup seal and spacer(s). Use the Chevron packing "part number"when ordering the U-cup seal and spacer(s).
Illustration 1. Hydraulic cylinder with chevron packing.
(A) Chevron packing. (B) Head. (C) Retainer.
Illustration 2. Hydraulic cylinder with the U-cup seal and spacer(s).
(A) Spacer(s). (B) U-cup seal. (C) Head. (D) Retainer.1. Remove the retainer and old Chevron packing. Keep the retainer for later use. Properly dispose of Chevron packing, see Illustration 1.2. Place the new U-cup seal between the head and rod, see illustration 2.3. Place the spacer(s) behind the U-cup seal.4. Install the retainer that was removed in step 1. There is not a need to put pressure on the seal/spacer(s) to install the new seal assembly. There needs to be a void between the U-cup seal and the head for sealing purposes.
This instruction gives the procedure for replacing the Chevron packing in an hydraulic cylinder with a U-cup seal and spacer(s). Use the Chevron packing "part number"when ordering the U-cup seal and spacer(s).
Illustration 1. Hydraulic cylinder with chevron packing.
(A) Chevron packing. (B) Head. (C) Retainer.
Illustration 2. Hydraulic cylinder with the U-cup seal and spacer(s).
(A) Spacer(s). (B) U-cup seal. (C) Head. (D) Retainer.1. Remove the retainer and old Chevron packing. Keep the retainer for later use. Properly dispose of Chevron packing, see Illustration 1.2. Place the new U-cup seal between the head and rod, see illustration 2.3. Place the spacer(s) behind the U-cup seal.4. Install the retainer that was removed in step 1. There is not a need to put pressure on the seal/spacer(s) to install the new seal assembly. There needs to be a void between the U-cup seal and the head for sealing purposes.
