ENGINE AR-COMPLETE 3144626 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A FT-2674 Vacuum Cap 1 Start By:
Remove the seat. Refer to Disassembly and Assembly, "Seat - Remove". Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01208165
Remove plates (1) and (2).
Illustration 2 g01196137
Attach Tooling (A) and an air supply to the hydraulic oil tank. Apply 345 70 kPa (50 10 psi) to Tooling (A).
Illustration 3 g01650893
Disconnect hose assemblies (3) and (4).
Illustration 4 g01208198
Disconnect harness assemblies (5).
Illustration 5 g01208202
Disconnect harness assemblies (6).
Illustration 6 g01208204
Remove plate (8). Move floor mat (7) toward the front of the cab.
Illustration 7 g01208208
Remove bolts (9) from each side of the operator console. Pull hose assemblies (3) and (4) through the floor of the cab. Pull harness assemblies (5) and (6) through the floor of the cab. Harness assemblies (5) and (6) were removed in Steps 4 and 5. Note: If the machine is equipped with a radio, the antenna will need to be disconnected.
Illustration 8 g01208250
Disconnect harness assembly (10).
Illustration 9 g01208252
Remove bolts (11) and operator console (12).