ENGINE AR 3187148 - Caterpillar

3187148 ENGINE AR Caterpillar parts C4.4

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3187148
318-7148
3187148

Buy ENGINE AR 3187148 Caterpillar genuine, new aftermarket tractor parts with delivery
INDUSTRIAL ENGINE,

Related part:

3187148 BLOCK GP-LONG 20R2686 R

Compatible equipment models: 3187148:

INDUSTRIAL ENGINE C4.4 Caterpillar

For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Name Qty
A(1) 9U-6198 Crankshaft Turning Tool 1
A(2) 9U-7336 Housing 1
5P-7305 Engine Turning Tool 1
(1) The Crankshaft Turning Tool is used on the front pulley.
(2) This Tool is used in the aperture for the electric starting motor.Start By:
Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove". Note: Either Tooling (A) can be used. Use the Tooling that is most suitable.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
If the crankshaft is installed, use Tooling (A) to rotate the crankshaft in order to gain access to the piston cooling jet.
Illustration 1 g01340939
Remove bolt (1) and piston cooling jet (2) from the cylinder block.
Repeat steps 1 and 2 for the remaining piston cooling jets. Installation Procedure
Table 2
Required Tools
Tool Part Number Part Name Qty
A(1) 9U-6198 Crankshaft Turning Tool 1
A(2) 9U-7336 Housing 1
5P-7305 Engine Turning Tool 1
(1) The Crankshaft Turning Tool is used on the front pulley.
(2) This Tool is used in the aperture for the electric starting motor.Note: Either Tooling (A) can be used. Use the Tooling that is most suitable.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01340940
Clean the piston cooling jets and inspect the piston cooling jets for damage. Ensure that the valve is free to move within each piston cooling jet. Replace any damaged piston cooling jets. The procedure for checking the alignment of the piston cooling jets is described in Specifications, "Piston Cooling Jet Alignment".
If the crankshaft is installed, use Tooling (A) to rotate the crankshaft in order to access the mounting flange for the piston cooling jet.
Position piston cooling jet (2) in the cylinder block. Install bolt (1). Tighten bolt (1) to a torque of 9 N m (80 lb in).
Repeat steps 2 through 3 for the remaining piston cooling jets. End By:
Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".