ENGINE AR-COMPLETE 3194726 - Caterpillar

Table 1
Diagnostic Codes For Magnet Controller ECM (SA No. 71)(1)
For troubleshooting, see the procedure with the same SPN And FMI No.
SPN / FMI Description
SPN 5000 Generator Overheat Status
FMI 11 Other Failure Mode.
SPN 5001 Genset System Output Voltage Range Status
FMI 11 Other Failure Mode.
SPN 5004 Genset Soft Start Active
FMI 3 Voltage above normal.
FMI 5 Current below normal.
FMI 6 Current above normal.
SPN 5005 Genset Enable Active
FMI 3 Voltage above normal.
FMI 5 Current below normal.
FMI 6 Current above normal.
SPN 5006 Voltage Monitor Active
FMI 3 Voltage above normal.
FMI 6 Current above normal.
SPN 5007 Generator Duty Cycle Exceeded Status
FMI 0 High
SPN 5008 Magnet Forward Current
FMI 3 Voltage above normal.
SPN 5009 Magnet Reverse Current
FMI 3 Voltage above normal.
SPN 5012 Generator Current Boost Active Status
FMI 3 Voltage above normal.
FMI 6 Current above normal.
SPN 5013 Material Lift Active Status
FMI 3 Voltage above normal.
FMI 5 Current below normal.
FMI 6 Current above normal.
SPN 5014 Material Drop Active
FMI 3 Voltage above normal.
FMI 5 Current below normal.
FMI 6 Current above normal.
(1) This table pertains only to diagnostic codes with a SA of 71.