ENGINE AR-PRIMARY 3452883 - Caterpillar

Illustration 1 g00104545Prevent the machine from movement. Park the machine on a level surface.Attach a "Do Not Operate" warning tag or a similar warning tag to the start switch or to the controls before you service the equipment. These warning tags (Special Instruction, SEHS7332) are available from your Caterpillar dealer.Required Parts
Table 1
327-7487 Foot Pedal Gp (- 04)
Item Qty Part No Description
(1) 1 121-1865 Rubber Pedal
(2) 1 233-5260 Lanyard
(3) 1 309-5808 Pedal Control Gp
(4) 1 328-4954 Pedal As
(5) 1 338-6811 Support As
(6) 1 357-3877 Pin
(7) 2 095-0735 Screw
(8) 2 7X-2536 Bolt
(9) 1 8T-0114 Spring Pin
(10) 3 8T-4121 Hard Washer
(11) 2 8T-4136 Bolt
(12) 1 8T-4137 Bolt
(13) 2 8T-4224 Hard Washer
Illustration 2 g06025878
Overview of the 327-7487 Foot Pedal Gp
Installation Procedure
Illustration 3 g06025894
(A) Removable access panel
Locate the small access panel (A) on the left side of the cab and remove as shown.Note: Remove the floor mat from the cab.
Properly reposition the floor mat on the floor of the cab.
From underneath the cab, use a marker to outline the area of the access hole on the bottom of the floor mat.
Remove the floor mat. Remove the material within the marked area of the mat. Ensure enough material is removed to allow control group (3) to pass through the mat.
Properly position the floor mat on the floor of the cab.
Illustration 4 g06025932
(1) 121-1865 Rubber Pedal
(2) 233-5260 Lanyard
(3) 309-5808 Pedal Control Gp
(4) 328-4954 Pedal As
(5) 338-6811 Support As
(6) 357-3877 Pin
(7) 095-0735 Screw
(8) 7X-2536 Bolt, 16.7 1.5 N m (12.5 1 lb ft)
(9) 8T-0114 Spring Pin
(13) 8T-4224 Hard Washer
Illustration 5 g06025938
(10) 8T-4121 Hard Washer
(11) 8T-4136 Bolt
Install pedal to floor as shown.
Unless specified, tighten all hardware and fittings to standard torque.
Illustration 6 g00687600
Check for leaks.