ENGINE AR-CORE 3470103 - Caterpillar

Oil Filter Base (Industrial Engine)
1. Remove filter assembly (5) with Tool (A).2. Disconnect oil line (1). Cap or plug all openings immediately.3. Remove six bolts (3) that hold the oil filter base to the cylinder block and four bolts (2) that hold the oil filter base to the oil cooler.4. Remove oil filter base (4).5. Remove the O-ring seals from the oil filter base.Install Oil Filter Base (Industrial Engine)
1. Put the four O-ring seals in position in oil filter base (3), and put the oil filter base in position on the cylinder block and oil cooler.2. Install four bolts (2) that hold the oil filter base to the oil cooler and six bolts (4) that hold the oil filter base to the cylinder block.3. Connect oil line (1) to the oil filter base.4. Put clean oil on the gasket for filter assembly (5), and install the filter assembly.5. Tighten the filter assembly3/4of a turn after the gasket makes contact with the oil filter base.Disassemble Oil Filter Base (Industrial Engine)
Start By:a. remove oil filter base Spring force is present behind covers (1).1. Remove the bolts and covers (1) from the oil filter base. 2. Remove springs (2) and valves (3) from the oil filter base. 3. If necessary, remove stud (4) from the oil filter base.Assemble Oil Filter Base (Industrial Engine)
1. Use 9S-3263 Thread Lockon stud (1) 7.62 mm (.300 in)from the taperlock end.2. Install stud (1) in oil filter base. Tighten the stud to a torque of 80 14 N m (60 10 lb ft). 3. Install valves (2) and springs (3) in the oil filter base. 4. Install covers (4) on the oil filter base.End By:a. install oil filter base