ENGINE AR-CORE 3470666 - Caterpillar

Table 1
Required Tools    
Part Number     Description     Quantity    
8T-5096     Dial Indicator Gp     1    Use this procedure in order to check for proper clutch assembly. Refer to Specifications, "Power Train" for running clearances for the clutch packs.
Illustration 1 g00904507
(1) Bearing (2) Disc (3) Gear assembly (4) Washer (5) Gear assembly (6) Disc (7) Rotor (8) Bearing (9) Carrier
Remove the following components from the clutch group:
Bearing (1)
Disc (2)
Gear assembly (3)
Washer (4)
Disc (5)
Gear assembly (6)
Rotor (7)
Bearing (8)
Carrier (9) Note: Do not use a puller to remove rotor (7) from the clutch assembly.
Illustration 2 g00904508
(10) Hub assembly (11) Ring (12) Clutch pack (13) Piston (14) Passage
Position the assembled clutch group with the shaft in the vertical position. Position the hub assembly of the clutch that is being measured so that the hub assembly faces upward.
Make sure that piston (13) moves freely.
Position the tip of a dial indicator on the flat of piston (13) at location (B). Zero the indicator.Note: Ensure that the tip of the indicator is parallel with the centerline of the shaft assembly.
Personal injury can result from applying air pressure without the lock ring securely in place. Make sure the lock ring (11) is securely in place before applying air pressure to the clutch pack.
To check the running clearance for the clutch packs, apply approximately 140 kPa (20 psi) air pressure to passage (14) for clutch pack (12) .
Piston (13) and clutch pack (12) should move up. Determine the amount of piston movement from the reading on the dial indicator. This is the running clearance for the clutch pack.Repeat Step 1 through Step 6 in order to determine the running clearances for the remaining clutch packs.